Manufacturer of precision tools, electric screwdrivers, digital thermometers, and alarm clocks designed for home improvement and DIY repairs.
ORIA is a consumer electronics and home improvement brand widely available on major e-commerce platforms. The brand specializes in providing affordable, high-utility tools and monitoring devices for DIY enthusiasts, technicians, and homeowners. ORIA is best known for its extensive range of precision screwdriver sets—both electric and manual—which are essential for repairing small electronics such as smartphones, laptops, and watches.
In addition to tools, ORIA manufactures a variety of environmental monitoring solutions, including digital hygrometers and thermometers for indoor, outdoor, and refrigerator use. The brand’s product portfolio also extends to home lifestyle items like LED digital alarm clocks and secure key storage lock boxes. ORIA products are designed with a focus on practicality, durability, and ease of use, making them a popular choice for everyday home maintenance and organization.
Latest manuals from manuals+ curated for this brand.
Watch setup, installation, and troubleshooting videos for this brand.
Common questions about manuals, registration, and support for this brand.
Most ORIA thermometers feature a specific button (often labeled C/F) located on the back or front of the device. Press or hold this button for a few seconds to toggle between units.
Press the 'ALARM' or 'SET' button (usually holding it down for a few seconds) until the time display flashes. Use the Up/Down buttons to adjust the hours and minutes, then press the Set button again to confirm.
First, ensure the device is fully charged using the provided USB cable. If the battery is charged but the motor does not run, check if the torque setting is too low for the resistance or if the bit is seated correctly.
Open the lock box using the current code. Locate the reset lever inside (usually pushing it from position A to B), rotate the dials to your new desired code, and then move the lever back to its original position to set the new code.