lumenradio W-Modbus Building Automation System With Wireless Modbus
Ƙayyadaddun bayanai
- Product Name: W-Modbus
- Connection: Wireless Modbus
- Installation Options: DIN rail, Wall mount
- Gateway Options: DIN rail, Wall mount
- Color Indicators: Blue (initial setup), Green (connection established), Yellow (secure mode), Blue blinking (ready to connect)
Connect Your Building Automation System with Wireless Modbus
This guide provides instructions for connecting your building automation system using wireless Modbus technology, eliminating the need for physical cables.
Ƙarshen Shigarwaview
For installation, no Modbus cables are needed. This setup is ideal for environments like hotels where cabling is impractical.
Kayayyakin da ake buƙata
You will need one of the following for installation:
- W-Modbus DIN Rail
- W-Modbus Wall Mount
Saita Umarnin
Saitin Ƙofar
Choose between DIN rail or wall mount options for your gateway. Set your Baud rate, stop bit, and parity on the gateway.
Set parity and stop bits using switches 3, 4, and 5 as needed.
Shigar da na'ura
A - Matsar da sauyawa zuwa "COMM" ko B - Matsar da canjin zuwa "
”. Continue by installing the LumenRadio node next to your field devices, starting with the one closest to your gateway.
Connecting to Controllers
Connect the LumenRadio device to your chosen device (zone or room controller). Optionally, set a local Baud rate.
Sanya na'urar LumenRadio zai fi dacewa sama da na'urar da aka zaɓa (mai kula da ɗaki) kuma haɗa. Zabi, saita ƙimar Baud na gida.
Node Activation
The lights on your node will sweep in blue.
When they start blinking green, the node has found the gateway. This can take up to five minutes.
Go back to the gateway
Secure Mode Activation
A - Matsar da sauyawa zuwa "GATEWAY" ko B - Matsar da sauyawa zuwa "
.”
Na'urorin suna kyaftawar rawaya suna shiga yanayin tsaro.
Wannan na iya ɗaukar har zuwa mintuna 5
Ƙarshen Shigarwa
Yanzu kuna da haɗin mara waya!
To use the W-Modbus app, press the button on the gateway three times until it blinks blue twice.
Verify your installation in the app and select “Network Map” for a detailed overview.
Ƙara koyo a www.lumenradio.com
FAQ
- Q: How do I know when the node has found the gateway?
A: The lights on the node will start blinking green when it has found the gateway, which may take up to five minutes. - Q: How do I enter secure mode?
A: Move the switch on the gateway to GATEWAY after connecting all devices. The devices will blink yellow as they enter secure mode.
Takardu / Albarkatu
 |
lumenradio W-Modbus Building Automation System With Wireless Modbus [pdf] Jagoran Shigarwa DIN rail, wall mount, W-Modbus Building Automation System With Wireless Modbus, W-Modbus, Building Automation System With Wireless Modbus, Automation System With Wireless Modbus, Wireless Modbus |