Sistema de automatización de edificios lumenradio W-Modbus con Modbus sen fíos
Especificacións
- Nome do produto: W-Modbus
- Conexión: Modbus sen fíos
- Opcións de instalación: Carril DIN, Montaxe na parede
- Opcións de pasarela: carril DIN, montaxe na parede
- Color Indicators: Blue (initial setup), Green (connection established), Yellow (secure mode), Blue blinking (ready to connect)
Connect Your Building Automation System with Wireless Modbus
This guide provides instructions for connecting your building automation system using wireless Modbus technology, eliminating the need for physical cables.
Instalación terminadaview
For installation, no Modbus cables are needed. This setup is ideal for environments like hotels where cabling is impractical.
Equipo necesario
You will need one of the following for installation:
- W-Modbus DIN Rail
- W-Modbus Wall Mount
Instrucións de configuración
Configuración de pasarela
Choose between DIN rail or wall mount options for your gateway. Set your Baud rate, stop bit, and parity on the gateway.
Set parity and stop bits using switches 3, 4, and 5 as needed.
Instalación do dispositivo
A - Move o interruptor a "COMM" ou B - Move o interruptor a "
”. Continue by installing the LumenRadio node next to your field devices, starting with the one closest to your gateway.
Connecting to Controllers
Connect the LumenRadio device to your chosen device (zone or room controller). Optionally, set a local Baud rate.
Coloque o dispositivo LumenRadio preferentemente encima do dispositivo escollido (controlador de sala) e conéctese. Opcionalmente, establece unha taxa de baudios local.
Node Activation
The lights on your node will sweep in blue.
When they start blinking green, the node has found the gateway. This can take up to five minutes.
Go back to the gateway
Secure Mode Activation
A - Move o interruptor a "GATEWAY" ou B - Move o interruptor a "
”.
Os dispositivos parpadean en amarelo entrando en modo seguro.
Isto pode levar ata 5 minutos
Finalizando a instalación
Agora tes unha conexión sen fíos!
To use the W-Modbus app, press the button on the gateway three times until it blinks blue twice.
Verify your installation in the app and select “Network Map” for a detailed overview.
Máis información en www.lumenradio.com
FAQ
- P: Como sei cando o nodo atopou a pasarela?
A: The lights on the node will start blinking green when it has found the gateway, which may take up to five minutes. - P: Como podo entrar no modo seguro?
A: Move the switch on the gateway to GATEWAY after connecting all devices. The devices will blink yellow as they enter secure mode.
Documentos/Recursos
 |
Sistema de automatización de edificios lumenradio W-Modbus con Modbus sen fíos [pdfGuía de instalación Carril DIN, montaxe na parede, Sistema de automatización de edificios W-Modbus con Modbus sen fíos, W-Modbus, Sistema de automatización de edificios con Modbus sen fíos, Sistema de automatización con Modbus sen fíos, Modbus sen fíos |