HOBBYEAGLE specializes in advanced 6-axis flight controllers and gyro stabilization systems for radio-controlled airplanes, enhancing flight stability and precision.
HOBBYEAGLE (HobbyEagle Electronic Technology Co., Ltd.) is a manufacturer dedicated to the development of flight stabilization systems for radio-controlled aircraft. The brand is well-known for its A3 series of gyroscopes, including the A3 Super 4, A3 Pro V2, and A3 Mini. These devices utilize high-precision 6-axis MEMS sensors to provide critical stability for fixed-wing airplanes, accommodating standard wings, delta wings, and V-tails.
HOBBYEAGLE products are designed for both beginners and experienced pilots, offering features that range from basic stability modes to advanced 3D flight locking and auto-hover capabilities. Their flight controllers support multiple receiver protocols, including standard PWM, PPM, and various digital serial protocols like S.Bus and DSMX. With user-friendly configuration tools and programming cards, HOBBYEAGLE ensures versatile setup options for safe and precise RC flight performance.
Latest manuals from manuals+ curated for this brand.
Common questions about manuals, registration, and support for this brand.
The gyro should be mounted as close to the Center of Gravity (C.G.) as possible using the supplied double-sided tape. It can be mounted flat, upright, or inverted, but the arrow on the unit must always align with the aircraft's heading direction.
HOBBYEAGLE gyros typically support standard PWM receivers (using individual channel wires) as well as single-line receivers using PPM or digital serial protocols such as S.Bus, DSM2/X, SRXL, and iBUS.
After powering on the aircraft, keep it completely stationary while the LED flashes (usually blue). The calibration is complete when the LED stays solid or indicates the active mode. Do not move the model during initialization.
Common modes include Normal (Rate) Mode for wind correction, Lock (AVCS) Mode for maintaining attitude, Angle (Trainer) Mode for limiting tilt, and Level/Hover modes for automatic leveling.
No, you should never use hot-melt glue or nylon ties to fix the gyro. Only use the supplied double-sided tape, as rigid or uneven mounting can cause vibration issues and affect sensor performance.