IKEA BAGGEBO Shelving Unit
Safety First: Preventing Tip-Over Accidents
⚠️ WARNING! Serious or fatal crushing injuries can occur if furniture tips over. To prevent tip-over, this furniture must be used with the wall attachment device(s) provided.
Screws and wall plugs for securing the unit to the wall are not included. You must use screws and plugs that are suitable for your specific wall type. If you are uncertain about the correct fasteners, please seek professional advice. Always read and follow each step of the instructions carefully.
Parts List
- Long screw (100229) - 10x
- Wooden dowel (101345) - 20x
- Small screw (109041) - 2x
- Washer (100823) - 4x
- Tool (100006) - 1x
- Plastic corner piece (122628) - 4x
- Shelf support (105494) - 1x
- Nail (101221) - Bag of approximately 30x (319503)
- Wall mounting bracket (106989) - 2x
Tools Required (Not Included)
- Screwdriver
- Hammer
- Ruler
- Pencil
Assembly Instructions
Attach four plastic corner pieces (122628) to the bottom edges of the two main side panels using a hammer.
Insert ten wooden dowels (101345) into the pre-drilled holes on the inner sides of the main panels.
Connect the base panel to the side panels using five screws (100229) and the provided tool (100006).
Insert ten wooden dowels (101345) into the holes on the top edges of the side panels.
Attach the top panel to the side panels using five screws (100229).
Mark the positions for the internal shelves on the side panels using a pencil and ruler.
Insert shelf supports (105494) into the marked positions. Secure each support with one nail (101221) using a hammer.
Place the shelves onto the supports and secure them from the sides with one nail (101221) per shelf.
Continue securing the remaining shelves with one nail (101221) per shelf.
Mark the position for the back panel using a pencil and ruler.
Secure the back panel to the unit using two nails (101221) at the top and twenty-five nails (101221) along the edges.
Attach the wall mounting bracket (106989) to the top rear edge of the unit using two small screws (109041) and two washers (100823).
Secure the assembled unit to the wall using the wall bracket. Ensure you use appropriate wall screws and plugs suitable for your wall type, as these are not included.