BEGA 22292 Wall Luminaire

Product Overview

Application: Wall luminaire for glare-free lighting of walls, traffic areas, and entrances. Features excellent lighting qualities and robust construction.

Diagram Description: The luminaire has a width of 160mm, a depth of 95mm, and projects 55mm from the wall. Mounting holes are Ø 5mm, spaced 120mm apart. Cable entries accommodate cables with a diameter of 7-10.5mm.

Product Description

• Materials: Aluminium alloy, aluminium, and stainless steel.
• Coating: BEGA Unidure(R) technology.
• Glass: Matt safety glass.
• Seal: Silicone gasket.
• Reflector: Pure anodised aluminium.
• Mounting: 2 holes, Ø 5mm, 120mm spacing.
• Cable Entries: 2 for through-wiring, Ø 7-10.5mm.
• Terminals: Connecting terminal and earth conductor terminal for 2.5mm² conductors.
• LED Power Supply: 220-240 V~ 0/50-60 Hz, DC 176-280 V.
• Features: BEGA Thermal Switch(R) for temporary thermal shutdown.
• Safety Class: I.
• Protection Class: IP 65 (dust-tight and protected against water jets).
• Impact Resistance: IK09 (protection against mechanical impacts < 10 joules).
• Certifications: [German electrical certification] (10 DE), CE Conformity mark.
• Weight: 1.0 kg.
• Energy Efficiency Class: D.

Safety Information

Installation and operation must comply with national safety regulations.

Only qualified electricians should perform installation and commissioning.

The manufacturer is not liable for damage caused by improper use or installation.

Any subsequent modifications will render the modifier as the manufacturer.

Technical Specifications

Lamp Details

• Module Connected Wattage: 7.8 W
• Luminaire Connected Wattage: 9.5 W
• Rated Temperature: ta = 25 °C
• Ambient Temperature: ta max = 50 °C

Overvoltage Protection

Electronic components are protected against overvoltage per DIN EN 61547. For additional protection against transients, separate overvoltage protection components are recommended. Find them at www.bega.com.

LED Module Specifications

Installation Instructions

Note: LEDs are high-quality electronic components. Avoid touching the light output surface directly during installation or relamping.

1. Undo screws and lift off the luminaire top.
2. Feed the mains supply cable through the cable entry into the luminaire housing.
3. Fix the luminaire base onto the mounting surface using the enclosed or other suitable fixing material. Ensure supplied gasket rings are used.
4. Make the earth conductor connection and the electrical connection.
5. Crucial: To ensure maximum lifespan of electrical components, insert the enclosed desiccant pouch (remove from foil packaging) into the luminaire at the position marked by the red label, immediately before finally closing.
6. Make the earth conductor connection between the luminaire top and base.
7. Ensure the gasket is correctly positioned.
8. Replace the luminaire top and tighten screws evenly.
9. Tighten screws uniformly in a crosswise fashion.

Cleaning and Maintenance

Clean the luminaire regularly with solvent-free cleansers to remove dirt and deposits.

Do not use high-pressure cleaners.

LED Module Replacement

The LED module designation is noted on a label inside the luminaire.

BEGA replacement modules match the original modules in light color and output.

Replacement can be performed by qualified persons using standard tools.

Procedure:

• Disconnect the system from power and open the luminaire.
• Follow the specific installation instructions for the LED module.
• Inspect luminaire gaskets and replace if necessary.
• Defective glass must be replaced.
• Close the luminaire.

Spares