FRÖSJÖN Shelf Unit Assembly Instructions
Safety Warning
[Warning] Children have died from furniture tipover. To reduce the risk of furniture tipover: ALWAYS install anti-tip device provided. NEVER put a TV on this product. NEVER allow children to stand, climb, or hang on any drawers, doors, or shelves. NEVER open more than one drawer at a time. Place heaviest items in the lowest drawers.
Parts List
- 1x Bracket (Part 100001)
- 22x Screw (Part 120940, 130498)
- 10x Screw (Part 10106941, 144201)
- 4x Foot (Part 10106975, 10116100)
Assembly Instructions
Step 1: Attach Feet
Take the base frame of the unit. Screw the four circular Feet (Part 10106975, 10116100) into the designated threaded holes at the bottom of the frame.
Step 2: Attach Side Supports
Attach the two vertical side supports to the base frame. Use the U-shaped Bracket (Part 100001) and six Screws (Part 120940, 130498) to secure them.
Step 3: Attach Horizontal Supports
Connect the horizontal support bars between the vertical side supports. Use five Screws (Part 120940, 130498) for this step.
Step 4: Attach Top Frame
Assemble the upper section of the shelving unit. Attach the top frame structure to the vertical side supports using eleven Screws (Part 120940, 130498).
Step 5: Insert Shelves
Carefully slide each of the shelves into the grooves or onto the support bars of the assembled frame.
Step 6: Secure Shelves
Secure each of the inserted shelves by fastening ten smaller Screws (Part 10106941, 144201) through the shelf supports into the shelves.
Step 7: Attach Top Decorative Elements
Attach the decorative elements at the very top of the unit. Use ten Screws (Part 10106941, 144201) to fix them in place.
Step 8: Level the Unit
Position the assembled unit in its desired location. Adjust the height of the Feet by screwing them in or out to ensure the unit stands level and stable on the floor.
Step 9: Secure to Wall
[Warning] To prevent tip-over accidents, it is essential to secure the unit to the wall. Attach the anti-tip hardware (not explicitly numbered, but provided) to the top rear of the unit and then to a wall stud using two screws.
