Important Safety Information
Visual warning icons: Exclamation mark, crossed-out television symbol, crossed-out furniture tip-over symbol.
WARNING: Furniture Tip-Over Hazard
Children have died from furniture tip-over. To reduce the risk of furniture tipover:
- ALWAYS install anti-tip device provided.
- NEVER put a TV on this product.
- NEVER allow children to stand, climb, or hang on any drawers, doors, or shelves.
- NEVER open more than one drawer at a time.
- Place heaviest items in the lowest drawers.
Diagrams illustrate the risk of furniture tip-over and the danger of placing a TV on furniture.
Parts Included
- 1x Handle-like piece (Part No: 100001)
- 22x Screws (Part No: 120940 / 130498)
- 10x Screws (Part No: 10106941 / 144201)
- 4x Feet/Caps (Part No: 10106975 / 10116100)
Visual representation of all included parts with their respective quantities and part numbers.
Assembly Instructions
General assembly overview: Tools required include a screwdriver and spirit level.
Diagrams show correct and incorrect ways to handle parts and assemble the unit.
A diagram shows a person seeking help from IKEA.
Step 1: Attach Feet
Attach the 4 feet (Part No: 10106975 / 10116100) to the base of the shelving unit frame.
Illustration shows the base frame and the 4 feet being screwed into the bottom.
Step 2: Attach Side Supports
Attach the side support pieces to the main frame using 6 screws (Part No: 120940 / 130498). Close-ups show the connection points.
Diagram shows side supports being attached to the main frame with screws.
Step 3: Attach Lower Horizontal Supports
Attach the lower horizontal supports to the frame using 5 screws (Part No: 100001).
Diagram shows lower horizontal bars being attached to the frame with screws.
Step 4: Attach Remaining Horizontal Supports
Attach the remaining horizontal supports to the frame using 11 screws (Part No: 120940 / 130498).
Diagram shows more horizontal bars being attached to the frame with screws.
Step 5: Insert Shelves
Insert the 5 shelves into the frame.
Illustration shows shelves being slid into place on the frame.
Step 6: Secure Shelves
Secure the shelves using 10 fasteners/clips (Part No: 10106941 / 144201).
Diagram shows fasteners/clips being inserted into holes to secure the shelves.
Step 7: Secure Shelves (Continued)
Secure the shelves again using 10 fasteners/clips (Part No: 10106941 / 144201).
Similar to Step 6, showing the fasteners securing the shelves from a different angle.
Step 8: Level the Unit
Level the unit by adjusting the feet. Ensure the unit is stable. Use a spirit level to check.
Illustration shows the assembled unit and a close-up of adjustable feet being turned to level the unit, with a spirit level shown.
Step 9: Secure to Wall (Anti-Tip Installation)
Secure the unit to the wall using the provided anti-tip hardware (2x screws). This is a critical safety step to prevent tip-over.
Diagram shows the shelving unit against a wall, with anti-tip hardware being attached to the unit and then secured to the wall.
