Taramps TAS 408F Active Box Instruction Manual
Model: TAS 408F
Power: 400W Musical
Installation of this product must be carried out by a qualified professional.
Product Overview
The TAS 408F active box is engineered to reproduce low frequencies, commonly known as sub-bass. It is responsible for delivering deep and impactful sounds within receiver systems, boasting a frequency response from 10Hz to 250Hz, ensuring accurate and natural audio reproduction across its entire range.
Technical Parameters
| Power | 400W Musical |
| Speaker Size | 8 INCH |
| Input Impedance | 2K Ohms |
| Sensitivity | 100 mV |
| Amplifier Class | D |
| Frequency Response (-3 dB) | 10 Hz a 250 Hz |
| Crossover LPF | 50Hz a 250Hz (-12dB/oitava) |
| Resonance Frequency | 29 Hz |
| Power Tension | 90 a 240 Vac (AUTOMATIC) |
| Maximum Consumption | 220Vac - 585W / 127Vac - 470W |
| Dimensions (HxWxD) | 335 x 272 x 382 mm |
| Acoustic Components | 1 SPEAKER 8 INCH |
| Cone Material | Polypropylene |
| Cabinet Type | Vented Box |
| Cabinet Finishing | Laminate |
| Color | Black Ebony |
| Fabric Finishing | Black Fabric |
| Cabinet Weight | 12.5 Kg |
| Product Warranty | 12 Months |
Product Dimensions
The product dimensions are as follows: Height: 335 mm (13.18 inches) Width: 272 mm (10.70 inches) Depth: 382 mm (15.03 inches)
Note: To achieve better sound quality, it's important to position the back of your speaker close to the wall, at a distance between 10 and 20 centimeters.
Controls and Connections
The rear panel of the TAS 408F features the following controls and connections:
- 1 - Power Cable: Connects the unit to the electricity network. Operates with a power supply between 90 and 240 VAC.
- 2 - ON / OFF Switch: Puts the product on standby, ready to be turned on using the DIRECT ON / AUDIO ON key.
- 3 - DIRECT ON / AUDIO ON:
- DIRECT ON: Turns the subwoofer on and off using the on/off switch.
- AUDIO ON: When set to this position, the product turns on when it receives an audio signal and turns off approximately 10 minutes after audio stops.
- 4 - SPEAKER OUT: Output for connecting a 4-ohm passive speaker (e.g., Taramps TPS 408F passive box).
- 5 - 0° / 180°: This switch inverts the phase of the audio signal by 180° to correct potential cancellations.
- 6 - LPF (Low Pass Filter): Allows variable adjustment of the maximum cutoff frequency from 50Hz to 250Hz. The "Home theater" mark on the scale suggests a setting for use in a movie theater environment.
- 7 - Volume: Adjusts the amplifier's input sensitivity, enabling precise alignment with the output signal levels of various audio sources.
- 8 - INPUT (RCA): Audio inputs. Connect these to the RCA outputs of your audio reproduction system using good quality shielded cables to prevent noise interference. For Mono or LFE connections, use the R input.
Starting The Subwoofer
Connect the receiver/pre-output to the subwoofer input using appropriate cables.
Connection diagram shows a RECEIVER unit with OUT L/R outputs connecting to the SUBWOOFER INPUT L/R. The INPUT section on the subwoofer has controls for LPF, Volume, and RCA inputs.
Taramps
