Naterial Vesuvia Metal Shed Assembly Instructions

Important Information

Please read these instructions carefully before assembly. Ensure you have all parts and tools required. Assembly requires at least two people. Wear appropriate safety gear, including gloves (EN 388 2121X). Maximum load capacity on roof is 75kg/m², and maximum wind speed resistance is 90km/h.

Safety Precautions:

• Do not assemble in windy conditions.
• Do not use power tools unless specified.
• Keep children and pets away from the assembly area.
• Ensure the assembly surface is perfectly flat and level.

Tools Recommended: Screwdriver, Hammer, Measuring Tape, Spirit Level, Safety Gloves, Safety Glasses.

Parts List

Refer to the detailed parts list provided in the original document for all components and their quantities. The list includes various metal panels, framing pieces, screws, nuts, and washers, identified by numbers and letters (e.g., 1L, 1R, F1, S3).

Assembly Steps

The assembly process is divided into numbered steps, each with detailed diagrams and part callouts. Follow each step sequentially for correct assembly.

Step 1-4: Assembling the Base Frame

Connect the base frame components (e.g., 1L, 1R, 2L, 2R, 3L, 3R) using screws (F1). Ensure the frame is square and level.

Step 5-6: Attaching Base Supports

Attach the base supports (e.g., part 5) to the frame using screws (F1).

Step 7-14: Erecting the Walls

Assemble the wall panels (e.g., P1, P2, P3, P4) and attach them to the base frame using various screws and fasteners (F1, F2, S3). Ensure panels are correctly oriented and secured.

Step 15-18: Installing Roof Supports

Attach roof support beams (e.g., 9, 10L, 10R, 11) to the top of the walls using screws (F1, S3).

Step 19-22: Attaching Roof Panels

Install the roof panels (e.g., P2, P3, 16, 16-1) to the roof supports using screws (F1, S3, F2). Ensure proper overlap and sealing.

Step 23-24: Installing Gable Ends and Supports

Attach gable end panels (e.g., 4L, 4R) and internal supports (e.g., 6) using screws (F1, F2, S3).

Step 25-26: Securing Roof and Walls

Continue attaching roof panels and securing the structure with screws (F1, S3). Install any remaining wall panels and supports (e.g., 6-1, 6-2).

Step 27-28: Installing Ridge Cap and Side Trim

Attach the ridge cap (e.g., 19, 20, 19-1) and side trim pieces (e.g., 17, GE) using screws (F1, S3).

Step 29-31: Finalizing Roof and Wall Connections

Complete the roof assembly by attaching final panels and trim (e.g., 15-1, 15-2, 24-1, 24-2, GC) using screws (F1, S3).

Step 32-35: Assembling and Attaching Doors

Assemble the doors (D1, D2) and attach them to the shed structure using hinges and fasteners (GD, GB, F2, S3).

Step 36-38: Final Touches and Anchoring

Install any remaining components, such as door handles or decorative elements. Securely anchor the shed to the ground according to local regulations and the provided instructions (using parts like J1, F7, F10).

Maintenance and Care

Regularly inspect the shed for any signs of damage or corrosion. Clean the shed with mild soap and water. Ensure proper ventilation to prevent condensation.

Disposal Information

Dispose of packaging materials responsibly. Follow local regulations for the disposal of the product at the end of its life cycle.