Revo Spot Light Installation Instructions
Product Specifications
| Specification | Details |
|---|---|
| Model No. | HV4002T-1-BLK, HV4002T-1-WHT |
| Name | Revo |
| Material | Aluminium |
| Colour | Black, White |
| IP Rating | IP20 |
| Input Voltage | 240v AC |
| Protection Class | 1 (Requires Earth) |
| Lamp Base | Built in LED |
| Lamp Wattage | 1x 8w |
| Colour Temp | TRI Colour - 3000k, 4000k, 5500k |
| Lumens | 640lm, 680lm, 720lm |
| CRI | >80+ |
| Wiring | Parallel |
| Dimmable | Yes |
| Warranty | 3 Years Replacement* |
Important Safety Issues
- This product must be installed by a qualified electrician according to AS/NZS 3000.
- Ensure all electrical mains are disconnected before any installation.
- Modification of this product will void any warranty.
- Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
- Aluminium and 304SS fittings must not be installed within 5km of any salt water environments.
- All o-rings and seals must be in place correctly to maintain warranty.
- This form may be updated at any time due to product improvements, please check online installation form for most current version.
Dimensions
The spot light features a main body diameter of 75mm (Ø75). The overall height of the fixture is 160mm. The mounting point is located 110mm from the bottom of the fixture. The base diameter is 55mm (Ø55). The fitting allows for 90° tilt and 270° swivel.
Installation Diagram
This diagram shows the components and wiring for installation. It depicts the spot light fixture, its mounting base, and the electrical connections, highlighting the earth, live, and neutral wires.
Mounting Base Diagram
The mounting base diagram shows a curved bracket with dimensions. It indicates two mounting holes of 10x4 mm. The overall width of the base is 69mm, with a depth of 43mm. The height of the mounting bracket is 15mm, and the distance between the mounting holes is 27mm.
Steps for Installation
- Make sure that the electrical circuit is free of voltage (master switch off).
- Remove allen screws on side of fitting and set aside.
- Install base plate in desired location.
- Connect the cable - use wire with earth; connect the earth first, then live and neutral wire.
- Fitting is preset to 3000k, to change slide switch to desired colour temperature.
- Reattach fitting to base plate making sure allen screws are tight.
- Adjust fitting to desired position making sure to stop rotating when fitting cannot rotate anymore. If forced fitting will continue to rotate and cause internal cables to become entangled causing fitting to short, warranty will be voided.
- All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Must be installed by a licensed electrician
Contact Details
143 Beauchamp Road
Matraville NSW 2036
Australia
Tel: 02 9381 8300
Fax: 02 9666 8881
Email: sales@havit.com.au
Web: www.havit.com.au
Warranty Terms & Conditions
Refer to the warranty information provided with the product or visit the Havit Lighting website for full terms and conditions.
Additional Information
For further product details and support, please visit the Havit Lighting website.
Havit Lighting
