Revo Spot Light Installation Instructions
Brand: Havit Lighting
Product Specifications
| Specification | HV4002T-3-BLK | HV4002T-3-WHT |
|---|---|---|
| Name | Revo | |
| Material | Aluminium | |
| Colour | Black | White |
| IP Rating | IP20 | |
| Input Voltage | 240v AC | |
| Protection Class | 1 [Class I - Requires Earth] ⏚ | |
| Lamp Base | Built in LED | |
| Lamp Wattage | 3x 8w | |
| Colour Temp | TRI Colour - 3000k, 4000k, 5500k | |
| Lumens | 3x 640lm, 3x 680lm, 3x 720lm | |
| CRI | >80+ | |
| Wiring | Parallel | |
| Dimmable | Yes | |
| Warranty | 3 Years Replacement* | |
Important Safety Issues
- This product must be installed by a qualified electrician according to AS/NZS 3000.
- Ensure all electrical mains are disconnected before any installation.
- Modification of this product will void any warranty.
- Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
- Aluminium and 304SS fittings must not be installed within 5km of any salt water environments.
- All o-rings and seals must be in place correctly to maintain warranty.
- This form may be updated at any time due to product improvements; please check online installation form for most current version.
Dimensions
Diagram 1 (Side View): Shows a three-spot light fitting. The main bar is 600mm long. The overall height from the mounting surface to the bottom of the light shades is approximately 110mm. Each spot light has a diameter of 55mm (Ø55). The spot lights are adjustable, with indications for 90° tilt and 270° swivel.
Diagram 2 (Top/Front View): Shows the overall length of the fitting is 585mm. The base plate has mounting holes spaced 180mm apart. There are two holes for cable entry, indicated as Ø20. There are also two smaller holes for screws, indicated as 2x Ø4. The depth of the fitting is approximately 50mm, with a height of 15mm for the base plate.
Mounting Base Diagram
An exploded view illustrating the mounting process. It depicts the base plate, screws, wall plugs, and the internal wiring terminal block. The terminal block is clearly labelled with 'L' for Live, 'N' for Neutral, and an Earth symbol [earth symbol] for ground connection.
Steps for Installation
- Make sure that the electrical circuit is free of voltage (master switch off).
- Remove allen screws on the side of the fitting and set aside.
- Install base plate in the desired location.
- Connect the cable - use wire with earth; connect the earth first, then live and neutral wire.
- The fitting is preset to 3000k; to change, use the slide switch to select the desired colour temperature.
- Reattach fitting to the base plate, making sure allen screws are tight.
- Adjust fitting to the desired position, making sure to stop rotating when the fitting cannot rotate anymore. If forced fitting continues to rotate, it may cause internal cables to become entangled, leading to a short circuit. If this is done, warranty will be voided.
- All connections must be carried out carefully; inspect all contacts before switching back on the electric circuit.
Contact Details
143 Beauchamp Road
Matraville NSW 2036
Australia
Tel: 02 9381 8300
Fax: 02 9666 8881
Email: sales@havit.com.au
Web: www.havit.com.au
Warranty Terms & Conditions
[QR code for warranty terms & conditions]
Additional Information
[QR code for additional information]
Note: Must be installed by a licensed electrician.
Havit Lighting
