Lena Lighting FACTOR HB Z LED

General Information and Safety

Assembly

Assembly should be carried out by a qualified person.

Cleaning

Dirtiness that settles on the diffuser due to normal operation of the fitting shall be cleaned with a damp cloth. Do not use abrasive cleaners.

WEEE Directive Compliance

This product is marked in accordance with the European Directive 2002/96/CE and Polish Act on used electric and electronic equipment with a symbol of a crossed-out waste container ?️. This mark informs that the device, after its application use, cannot be placed together with other types of household waste. The user is obliged to return it to entities conducting the collection of used electric and electronic equipment. Proper proceeding with used electric and electronic equipment contributes to the avoidance of damaging consequences for health and the environment.

Installation Steps

1. Step 1: Power Off

   Ensure the power is turned off before proceeding. ?

   Diagram Description: Shows a power symbol indicating 'POWER OFF' with a hand gesture.

2. Step 2: Mounting (1-Module Version)

   For a 1-module version, secure the mounting bracket (A) using four screws (B).

   Diagram Description: Shows a luminaire body with a bracket labeled 'A' and screws labeled 'B', indicating attachment.

3. Step 3: Mounting (2-Module Version)

   For a 2-module version, secure the mounting bracket (A) using four screws (B).

   Diagram Description: Similar to the 1-module version, showing bracket and screw attachment for a larger luminaire body.

4. Step 4: Cable Connection

   Connect the power cable (H07RN-F 3x1.5mm², Ø=6-10mm) to the IP66 rated connector. Ensure a secure connection with a 'click' sound ?.

   Wire Connections:

   • L-L (Live)
   • N-N (Neutral)
   • PE-PE (Earth/Ground)

   Diagram Description: Illustrates connecting a cable through a waterproof gland, showing the 'click' mechanism and terminal identification for Live, Neutral, and Earth.

5. Step 5: DALI Connection (Version 1)

   For DALI Version 1, connect the DALI wires as follows:

   • L1 to L1 (DA)
   • L2 to L2 (DA)

   Diagram Description: Shows a DALI connector with terminals labeled L1, L2, N, and symbols indicating DALI connections.

6. Step 6: DALI Connection (Version 2)

   For DALI Version 2, connect the DALI wires to terminals 4 (DA) and 5 (DA). Connect Neutral to terminal 2 (N) and Live to terminal 3 (L).

   Diagram Description: Shows a DALI connector with terminals numbered 1-5, indicating specific connections for DALI, Neutral, and Live.

7. Step 7: Power On

   Once installation is complete, restore power. ?

   Diagram Description: Shows a power button symbol indicating 'POWER ON'.

Dimensions

The luminaire has a length of 357 mm. The height is approximately 273 mm for the 2-module version.

Diagram Description: Shows a top-down view of the luminaire with dimensions indicated: 357 mm length and 77 mm width. A side view shows a height of approximately 273 mm for the 2-module variant.

Technical Specifications

• Product Type: Industrial LED Luminaire
• Model: FACTOR HB Z LED
• Versions: 1 - 2 Module
• Ingress Protection: IP66
• Impact Resistance: IK09
• Voltage: 220-240 V
• Frequency: 50/60 Hz
• Certifications: CE, UKCA
• Control: DALI (optional, depending on version)