Baris LED Bracket Installation Instructions
Brand: LENA LIGHTING
Model: Baris LED Bracket
Specifications: LED, IP44, 220-240 V, 50-60 Hz, CE
WEEE Compliance
This product is marked in accordance with the European Directive 2002/96/CE and Polish Act on used electric and electronic equipment with a sign of a crossed-out waste container: ?️. This mark informs that the device, after its use, cannot be placed together with other household waste. The user is obliged to return it to designated collection entities. Proper disposal helps avoid harmful consequences for health and the environment.
Product Dimensions
| TYPE | A [mm] | B [mm] | C [mm] | D [mm] | E [mm] |
|---|---|---|---|---|---|
| 510 mm | 165 | 580 | 53 | 40 | 71 |
| 860 mm | 165 | 860 | 53 | 40 | 71 |
Installation Steps
Step 1: Preparation and Safety
Assembly should be carried out by a qualified person. Ensure the power supply is turned off before installation. [Power symbol] OFF.
Illustration: Hand turning off power.
Step 2: Mounting the Bracket
Locate the mounting points on the wall. Use the provided screws and wall plugs (if necessary) to securely attach the mounting bracket.Illustration: Mounting screws and wall plugs.
Step 3: Wiring Connections
Connect the power supply wires to the corresponding terminals on the lamp's backplate:
- L: Live
- N: Neutral
- DALI: DA+ (DALI Positive), DA- (DALI Negative)
Illustration: Lamp backplate with wiring terminals (L, N, DALI) and arrows indicating correct orientation.
Step 4: Attaching the Lamp
Align the lamp with the mounted bracket and secure it by pushing until it clicks into place. [Click sound effect indicated].
Illustration: Lamp being attached to the mounting bracket with a 'CLICK!' indication.
Step 5: Final Check and Power On
Ensure the lamp is securely attached and all electrical connections are correct. Turn on the power supply. [Power symbol] ON.
Maintenance and Care
Cleaning
Dirt and dust on the diffuser should be cleaned with a damp cloth. Do not use abrasive cleaners.
Illustration: Hand cleaning lamp diffuser with a damp cloth.
Light Source Replacement
The light source should only be replaced by the manufacturer, their maintenance representative, or a similarly qualified person.
Application Notes
This luminaire is intended for indoor traffic zones as specified in table 5.1 of the EN12464 standard. This applies only to the VD version.
Contact Information
Manufacturer: LENA LIGHTING S.A.
Address: ul. Kornicka 52, 63-000 Sroda Wlkp. POLAND
Phone: +48 61 28 60 300
Email: office@lenalighting.pl
Website: www.lenalighting.pl
Polski Producent Oświetlenia LED - Lena Lighting S.A.
