CORSTON ARCHITECTURAL DETAIL
Perryn spotlights
INSTRUCTIONS
Single spotlight
Included
A diagram shows a single spotlight fixture with a cylindrical shade and an adjustable head, labeled 'Single spotlight x1'.
Tools You'll Need
- Drill
- 40mm holesaw
- Crosshead screwdriver
Safety and Installation Notes
Before installation, the power supply should be isolated at the consumer unit circuit breaker. Check that the power is off.
These products must be installed by a qualified electrician in accordance with the latest building regulations.
The Perryn single spotlight is designed to be mounted onto a ceiling or wall with a void.
Note: The Perryn spotlight should not be covered with a thermally insulating material.
Installation Steps
Step 1: Prepare the Hole
Drill the 40mm hole for the wires and latching mechanism. Refer to the template provided.
Step 2: Insert the Fitting
Fold the two spring clips inwards and insert the fitting through the prepared hole, clips first.
Step 3: Secure the Spotlight
Push the spotlight up into the ceiling until the springs engage and hold it in position. Position the spotlight as required.
Step 4: Install Bulb and Test
After positioning, insert a 50mm GU10 bulb (Arthur or Chester) or a 35mm bulb (Court) into the shade. Test the light to ensure the wiring is correct.
Template
A diagram shows a template with a 40mm diameter circle and dashed alignment lines. Text indicates 'Print on A4'.
Double spotlight
Included
A diagram shows a double spotlight fixture with two cylindrical shades and an adjustable bar, labeled 'Double spotlight x1'.
Tools You'll Need
- Drill
- 40mm holesaw
- Crosshead screwdriver
Safety and Installation Notes
Before installation, the power supply should be isolated at the consumer unit circuit breaker. Check that the power is off.
These products must be installed by a qualified electrician in accordance with the latest building regulations.
The Perryn double spotlight is designed to be mounted onto a ceiling or wall with a void.
Note: The Perryn double spotlight should not be covered with a thermally insulating material.
Installation Steps
Step 1: Prepare the Holes
Drill two 40mm holes for the wires and latching mechanism, spaced 15cm apart. Using a small saw, cut a track connecting the two holes.
Step 2: Insert the Fitting
Fold the four spring clips inwards and insert the fitting through the prepared holes, clips first.
Step 3: Secure the Spotlight
Push the spotlight up into the ceiling until the springs engage and hold it in position. Position the shades as required.
Step 4: Install Bulbs and Test
After positioning, insert 50mm GU10 bulbs (Arthur or Chester) or 35mm bulbs (Court) into the shades. Test the lights to ensure the wiring is correct.
Template
A diagram shows a template with two 40mm diameter circles, spaced 150mm apart, connected by a dashed line. Text indicates 'Print on A4'.
