Neomounts NM-D335D4BLACK Monitor Desk Mount Installation Guide

Step 1: Prepare the Base

Choose your preferred mounting method:

1A: Desk Clamp Installation

Attach the clamp [J] to the pole [D]. Position the clamp on the edge of your desk and tighten securely.

1B: Desk Grommet Installation

Attach the grommet mount [B] to the pole [D]. Insert the grommet mount through an existing desk grommet hole and secure it.

Diagram Description: Illustrates two methods for attaching the base to the desk: a clamp that grips the desk edge, and a grommet mount that passes through a desk hole.

Step 1: Assemble the Pole to the Base

Mount the pole [D] to the base plate [E] that is now attached to your desk.

Diagram Description: Shows the main vertical pole being attached to the base structure already fixed to the desk.

Step 2: Install Limiting Ring

Install the limiting ring onto the pole [D]. This ring may help set a maximum height limit for the mount.

Diagram Description: Depicts a ring being slid onto the main vertical pole.

Step 3: Connect Crossbars

Connect the two crossbars [F] using the provided intermediate piece. This forms the main arm structure for the monitors.

Diagram Description: Shows the two horizontal crossbars being joined together, likely with a central connecting piece, to create the monitor support arm.

Step 4: Attach VESA Plates

Attach the VESA mounting plates to the ends of the crossbars [F] using the appropriate screws.

Diagram Description: Illustrates the VESA mounting plates being secured to the ends of the assembled crossbars.

Step 5: Mount Crossbar Assembly to Pole

Attach the assembled crossbar unit to the main pole [D]. Install the cable clips [I] along the pole for cable management.

Diagram Description: Shows the complete crossbar assembly being connected to the top of the main pole, and cable management clips being attached to the pole.

Step 6: Adjust Mount Position

Position the mount arm as desired. Use the adjustment knob [R] to loosen or tighten the joints for smooth movement.

Diagram Description: Illustrates adjusting the position of the monitor arm, highlighting a knob used for tightening or loosening the joint.

Step 7: Mount Upper Rod Component

Attach the upper rod cap [H] to the top of the pole [D].

Diagram Description: Shows a cap or cover being fitted onto the very top of the main vertical pole.

Step 8: Secure Crossbar to Pole

Ensure the crossbar assembly is securely attached to the pole [D].

Diagram Description: A final check or securing step for the crossbar assembly onto the main pole.

Step 9: Attach Monitor to VESA Plates

Align the monitor's VESA mounting holes with the VESA plates on the crossbar. Use the provided screws (e.g., M4x12mm [M-A], M5x12mm [M-B], D5 Washers [M-C]) to attach the monitor. Ensure to leave approximately 3mm of space between the monitor and the VESA plate. Some screws may not be included.

Diagram Description: Shows a monitor being attached to the VESA plates using screws. It indicates the use of specific screw types and washers, and notes that some hardware might not be included. A 3mm gap is indicated.

Step 10: Secure Monitors

Attach the screens to the bracket and secure them firmly using the appropriate hardware.

Diagram Description: Depicts the monitors fully attached and secured to the VESA plates on the mount arms.

Step 11: Adjust Tilt and Torque

Adjust the tilt of the monitors to your preferred angle, within the range of +45° to -45°. Adjust the torque on the arm joints using the Allen key [R] to ensure smooth yet stable positioning.

Diagram Description: Illustrates adjusting the tilt angle of the monitor arms, showing the +45° and -45° limits. It also shows the use of an Allen key to adjust the torque of the arm joints.