B095-772 Assembly Instructions
Signature Design by Ashley
Important Safety Notices
Always use proper tools. Follow the assembly steps in order and do not skip any. Check all packing materials carefully for small parts that may have come loose during shipment. If parts are missing, contact the retailer from which you purchased the product to obtain any missing parts. DO NOT USE SUBSTITUTE PARTS. Periodically check to ensure that all connectors (bolts, screws, etc.) are tight. Keep the instructions for future reference.
Be very careful when handling glass or mirrors, as severe injury may result if they break. Never handle large pieces of glass or mirrors alone. When assembling products with electric cords (lamps, lights, etc.), always ensure the electrical cord is unplugged before assembly and be careful not to twist the electrical cord during assembly.
Do not stand on lower shelves to assemble upper shelves; use a step ladder. Do not stand on tables (end tables, coffee tables, dinner tables), as they are not designed to support a person's weight. Where assembly instructions state that two or more people are required, do not attempt by yourself as there is a risk of injury.
Note: Ashley Furniture Industries, LLC disclaims any liability for damages or injuries which may occur due to failure to properly follow assembly instructions, properly assemble the product, or properly use the product.
Note: Your unit may look different in appearance from the one shown in the illustrations on this instruction sheet.
Parts List
- Part A: Side Rail (x2)
- Part B: Cross Slat Support Leg (x2)
- Part C: Cross Slat (Set) (x2)
- Part D: Center Support Rail (x1)
- Part E: Foot (x4)
- Part F: Leg (x4)
- Part G: Support Piece (x4)
- Part H: Bolt (1/4"x22mm) (x24)
- Part J: Screw (8x30mm) (x16)
- Part K: Allen Wrench (x1)
- Tools not included: M8x30, M4
Assembly Steps
Step 1: Attach Feet to Legs
Insert the leg (F) into the base of the foot (E). Repeat four times.
Step 2: Attach Support Legs to Side Rails
Take one cross slat support leg (B) and align it with the pre-drilled holes on a side rail (A). Secure using four 1/4"x22mm bolts (H). Repeat for the second support leg (B) on the same side rail (A).
Step 3: Attach Remaining Support Legs
Repeat Step 2 for the other side rail (A) and its two cross slat support legs (B).
Step 4: Assemble Base Frame
The side rail assemblies, now with legs (F) and support legs (B) attached, form the base frame.
Step 5: Attach Center Support Rail
Position the center support rail (D) between the two side rail assemblies. Align the ends of the center support rail (D) with the inner cross slat support legs (B). Secure each end of the center support rail (D) to the support legs (B) using two 1/4"x22mm bolts (H) per connection. Total of eight 1/4"x22mm bolts (H) used for this step.
Step 6: Attach Support Pieces
Attach the support pieces (G) to the top of the cross slat support legs (B). Repeat four times.
Step 7: Place Cross Slats
Place the cross slats (C) onto the assembled frame, resting them on the side rails (A) and the center support rail (D).
Step 8: Secure Cross Slats
Secure each cross slat (C) to the support legs (B) using two 8x30mm screws (J). Repeat for all cross slats, using a total of sixteen screws (J).
Step 9: Adjust Levelers
Turn the adjustable leveler on the bottom of the Cross-Slat Support Leg (B) to leave approximately 6mm (approx. 1/4 inch) space between the leveler and the floor. This ensures stability.
Step 10: Final Notes
Important: Always disassemble the bed prior to moving it to a new location.
