Signature Design by Ashley Bed Assembly Instructions

Important Safety Notice

Always use proper tools. Follow assembly steps in order. Check all packing materials for loose parts. Contact retailer for missing parts; do not use substitute parts. Periodically check that all connectors are tight. Keep instructions for future reference.

Handle glass or mirrors with extreme care to avoid injury. Never handle large pieces of glass or mirrors alone. When assembling products with electric cords, ensure the cord is unplugged before assembly and be careful not to twist it. Do not stand on shelves to assemble upper shelves; use a step ladder. Do not stand on tables as they are not designed to support a person's weight. If assembly requires two or more people, do not attempt alone due to risk of injury.

Note: Ashley Furniture Industries, LLC disclaims liability for damages or injuries due to failure to follow assembly instructions, improper assembly, or improper product use.

Note: Your unit may look different in appearance from the one shown in the illustrations.

Parts List

All parts required for assembly are packed in the open space in the back of the headboard panel.

• A x 1
• B x 1
• C x 2
• D x 2
• E x 2
• F x 2
• G x 2
• H x 4
• J x 4
• K x 8
• L x 2
• M x 8
• N x 8
• P x 28
• R x 4
• S x 1
• T x 2

Hardware sizes include:

• 5/16" X 80mm
• 5/16"x60mm
• 5/16"x25mm
• 1/4"x35mm
• 1/4"x20mm
• M4
• 80x25mm

For replacement parts, contact RTAParts@ashleyfurniture.com or visit www.ashleyfurniture.parts.

Assembly Steps

Step 1: Attach part M (x8) with 5/16"x60mm bolts (S) to parts A (x2) and E (x2). Ensure not to tighten any bolts until all have been started. This step requires two or more people.

Step 2: Attach part L (x2) using 5/16"x80mm bolts (S) to parts B (x1) and F (x2). Use part S (x2) per connection.

Step 3: Attach part H (x4) to parts C/D (x2) using P x 3 (1/4"x35mm) bolts. Use P x 3 (x3) per connection.

Step 4: Attach part T (x1) to part C (x1) using R x 2 (1/4"x20mm) bolts and P x 4 (1/4"x35mm) bolts. Use P x 1 (x1) and S x 1 (x1) per connection.

Step 5: Attach part N (x8) to the assembled frame using S (x4) and P (x1) per connection.

Step 6: Insert P x 8 (1/4"x35mm) bolts (S) into the support legs.

Step 7: Turn the adjustable leveler on the bottom of the Cross-Slat Support Leg, leaving approximately 6mm space between the leveler and the floor.

Note: Always disassemble the bed prior to moving to a new location.