DEJSA Ceiling Lamp Assembly Instructions
Product: DEJSA Ceiling Lamp
Brand: IKEA
Model Numbers: 004.307.69, 904.780.40, 304.780.38, 204.780.34
Important Safety Information
For indoor use only.
IMPORTANT! Always shut off power to the circuit before starting installation. In some countries, electrical installation must be performed by an authorized electrician. Consult local authorities for advice. Use screws and plugs suitable for your specific wall material.
Tools Required
- Screwdriver
- Scissors
- Tape measure
Refer to IKEA for assistance if needed.
Assembly Steps
Step 1: Mount Ceiling Bracket
Securely attach the mounting bracket to the ceiling using appropriate fixings. The diagram shows the bracket being fastened with screws.
Step 2: Route Power Wires
Thread the main power supply wires through the central opening of the mounting bracket.
Step 3: Connect Main Wires
Connect the incoming power wires to the terminal block inside the lamp's canopy. Ensure correct connection of Live (L) and Neutral (N) wires.
Step 4: Attach Lamp Body
Mount the main lamp body onto the ceiling bracket. Align and secure it with screws.
Step 5: Prepare Arm Wires
Prepare the wires for the lamp arms by stripping approximately 20 mm (13/16") of insulation from the end of each wire.
Step 6: Install Lamp Arms
Insert the prepared lamp arms into their respective sockets on the lamp body and secure them.
Step 7: Connect Arm Wires to Terminal Block
Connect the wires from each lamp arm to the corresponding terminals in the lamp's junction box.
Step 8: Final Wiring
Ensure correct wiring: Live (L) to 'L' terminal and Neutral (N) to 'N' terminal in the junction box. The diagram illustrates the correct wire insertion.
Step 9: Attach Lamp Shades to Arms
Attach the glass shades to the lamp arms. Secure them using the provided screws or locking mechanisms.
Step 10: Secure Lamp to Ceiling
Mount the main lamp body to the ceiling bracket. The diagram shows the canopy being attached to the bracket.
Step 11: Attach Glass Shades
Attach the glass shades to the lamp sockets. Twist them clockwise until securely fastened.
Step 12: Insert Light Bulbs
Insert light bulbs into the sockets. Ensure they are screwed in firmly.
Step 13: Final Shade Check
The final step shows a hand securing a glass shade, confirming all shades are properly attached.
