Nespresso Vertuo Creatista Descaling Guide

About Descaling

Nespresso recommends descaling your Vertuo Creatista machine every 3 months or after 300 capsules, whichever comes first. Regular descaling removes mineral buildup and ensures your machine operates efficiently, producing the best coffee quality.

Use only the official Nespresso Descaling Kit (NDA-16). Other solutions, such as vinegar or store-bought descalers, may damage your Nespresso machine.

Important Safety Information:

• The descaling solution can damage or discolor surfaces. Place protective material underneath your machine during the process.
• Clean up any spills immediately to prevent damage.
• Keep the descaling solution out of reach of children.
• In case of contact with eyes: Rinse cautiously with water for at least 15 minutes and seek immediate medical advice.
• Do not swallow or ingest the descaling solution.
• The solution may be irritating to eyes and skin.
• Avoid filling the water tank while the machine is descaling.

The descaling agent packaging also contains important safety warnings in multiple languages including French, German, Italian, Spanish, Dutch, and Polish.

Descaling Procedure

Estimated Duration: 25 Minutes

Tip: Before starting the descaling process, it is recommended to clean the steam wand tip.

Note: The descaling and rinse cycles can be paused or resumed at any time by pressing the Steam button.

When to Descale:

Descaling is indicated when the descaling light on your machine blinks orange.

Steps:

1. Step 1: Preparation

   Eject any capsules from the machine. Empty the capsule container and drip tray. Place them back onto the machine.

2. Step 2: Add Descaling Solution

   Fill the water tank with 33.81 ounces (1 liter) of water up to the marked descaling line. Add 2 packets of Nespresso descaling solution to the water. Place the water tank back onto the machine.

   *Avoid contact of the solution with eyes, skin, and kitchen surfaces.

3. Step 3: Set Up Container

   Place an empty container, capable of holding at least 65 ounces (2 liters), under the coffee outlet and the steam wand. Turn the machine on. Close the machine head and lock the lever.

4. Step 4: Initiate Descaling Cycle

   Press and hold the Steam button and the Milk Temperature button simultaneously for approximately 5 seconds. The descaling light should turn steady yellow, the bottom and middle temperature indicator lights should illuminate, and the Steam button should flash orange.

5. Step 5: Run Descaling Cycle

   Press and release the Steam button to begin the steam and coffee descaling cycle. The descaling light and the Steam button will remain lit and steady. The middle temperature light will blink red during this process.

6. Step 6: Cycle Completion & Cleanup

   Once the descaling cycle is complete, the Steam button will flash, and only the bottom temperature light will remain illuminated. Discard the used descaling solution from the container.

   Remove, empty, and rinse the water tank, capsule container, and drip tray.

7. Step 7: Rinse Cycle Preparation

   Refill the water tank to the MAX line with fresh water. Reattach the water tank to the machine.

   Replace the capsule container and drip tray on the machine. Ensure the empty container is positioned correctly under the coffee spout and steam wand.

8. Step 8: Initiate Rinse Cycle

   Press and release the Steam button to begin the rinse cycle.

   During the rinse cycle, the descaling light and the Steam button will be lit and steady. The bottom temperature light will flash red. The coffee cup button will begin to flash orange as the coffee side starts rinsing.

9. Step 9: Rinse Cycle Completion

   Once the rinse cycle is complete, the machine will automatically exit the descaling mode. All indicator lights will return to their ready status.

10. Step 10: Final Steps

    Empty any remaining rinsing water from the container. Remove, empty, and rinse the water tank, capsule container, and drip tray one last time.

    Refill the water tank with fresh water and place it back onto the machine.

    Replace the capsule container and drip tray on the machine.

    Wipe down the exterior of the machine with a damp cloth. Allow the machine to rest for 10 minutes. Your Nespresso Vertuo Creatista is now ready for use.