Nespresso Essenza Plus Descaling Guide
Important Information Before You Begin
Nespresso recommends descaling every 3 months or 300 capsules, whichever comes first.
Use only the Nespresso Descaling Kit, which contains a natural solution designed to dissolve scale buildup. Other solutions, such as vinegar or store-bought descalers, may damage your Nespresso machine.
Caution: Descaling solution can damage or discolor surfaces. Place protective material underneath your machine to catch potential spills. Clean up any spills immediately to prevent damage.
Safety Precautions:
- Keep descaling solution out of reach of children.
- In case of contact with eyes, rinse immediately with plenty of water for 15 minutes and seek medical advice.
- Do not swallow or ingest the descaling solution. It may be irritating to the eyes and skin.
During Descaling:
- Avoid filling the water tank during the descaling process.
- After descaling, wipe down the machine with a damp cloth.
Essenza Plus Descaling Procedure
Duration: 15-20 minutes
Requires: 1 packet of Nespresso descaling solution
Step 1: Check Descaling Indicator
The orange descaling light blinking indicates it is time to descale.
Step 2: Eject Capsule
Open and close the lever to eject any used capsule.
Step 3: Prepare Machine Base
Empty the drip tray and capsule container and replace them on the machine. The cup support can be set aside.
Step 4: Prepare Water Tank
Fill the water tank halfway full with water (approximately 17 oz). Add 1 packet of Nespresso descaling solution to the water.
Step 5: Position Container
Place a container with a minimum capacity of 33.8 oz under the coffee spout.
Step 6: Enter Descaling Mode
Ensure the machine is on and warmed up. Press and hold the Espresso, Lungo, and Hot Water buttons simultaneously for approximately 5 seconds until all lights start blinking.
Step 7: Confirm Descaling Mode
The descaling light will become steady if the 3 main buttons are no longer blinking underneath your fingers.
Step 8: Start Descaling Cycle
To exit descaling mode at this point, press and release either the Espresso or Lungo button. To begin the descaling process, press and release the Hot Water button. The descaling alert light will remain illuminated, and the 3 buttons will scroll from rear to front as descaling commences.
Step 9: Complete Descaling Flow
The descaling solution will dispense through the coffee spout, alternating between outlets if applicable. Wait until the water tank is completely empty. The 3 buttons will blink simultaneously again, indicating the end of the descaling cycle.
Step 10: Discard Solution and Clean Tray
Discard the used descaling solution. Empty the drip tray and replace it on the machine.
Step 11: Rinse Water Tank and Refill
Wash and rinse the water tank thoroughly. Fill the water tank with fresh water and place it back on the machine.
Step 12: Reposition Container
Replace the empty container under the coffee spout.
Step 13: Start Rinsing Cycle
To begin the rinsing process, press and release the Hot Water button. The descaling alert light will stay on, and the 3 buttons will scroll from rear to front as rinsing begins. Once the water tank is empty and the machine stops running, repeat steps 11 through 13 to perform a second rinse cycle.
Step 14: Finalize Process
The machine will turn off automatically when the rinsing is complete. Discard the rinsing water, empty the drip tray and replace it. Wipe down the machine with a damp cloth. Refill the water tank. The descaling process is now complete.
