NOVA LIFE Interior Floor Lamp for BECKY
Art Nr. 30080-002-20, 30057-002-21
Package Contents
Parts are not to scale:
[Diagram: A visual representation showing the disassembled parts of the floor lamp. Key components include the lamp head assembly with flexible arms and wires, a base iron plate, a bottom pad, a wrench, glass shades, a cross screwdriver, a lampholder tightening tool, and tapping screws.]
| Part | Description | Quantity |
|---|---|---|
| A | The fixture with wire | 1 |
| B | Bottom pad | 1 |
| C | Base iron plate | 1 |
| D | Wrench | 1 |
| E | Glass | 2 |
| F | Cross Screwdriver | 1 |
| G | Lampholder tighten tool | 1 |
| H | Tapping screws | 3 |
Light Source
Requires 2 x 230V G9 28W Max bulbs (not included). LED bulbs are recommended.
Care and Cleaning
Exterior Maintenance
- To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the surface of the fixture.
- Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft cloth to dust or wipe carefully.
Safety Information
CAUTION ⚠️
Warning:
- Only use bulbs as directed on the label on the lamp.
- Turn off the lamp before replacing the bulb and wait until the bulb has cooled. Take special care to touch the lamp when the lamp is lit. It can be hot.
(Original warnings in Norwegian: Bruk kun pærer som anvist etiketten på lampen. Slå av lampen før bytting av pære og vent til pæren er avkjølt. Vis forsiktighet ved berøring av lampen når den er tent. Den kan være varm.)
(Original warnings in Swedish: Använd endast glödlampor enligt anvisningar på lampans etikett. Stäng av lampan innan du byter glödlampa och vänta tills lampan har svalnat. Var särskilt försiktig vid beröring av lampan när den är tänd. Det kan vara varmt.)
Installation
Pre-Installation
Planning the Installation
Read all instructions before assembly and installation. Before starting installation of the fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. To avoid damaging this product, assemble it on a soft, non-abrasive surface such as carpet or cardboard.
Tools Required
- [knife] Knife
Assembly Steps
Step 1: Lamp Head and Pole Assembly
[Diagram: Shows the upper part of the lamp pole with flexible arms and lamp heads. Numbered indicators show attachment points.] Attach the lamp head assembly (1) to the top of the pole.
Step 2: Base Assembly
[Diagram: Illustrates the base assembly with base iron plate, bottom pad, and screws.] Assemble the base by attaching the bottom pad (2) to the base iron plate (1) using screws (4).
Step 3: Electrical Connection
[Diagram: Depicts electrical wire connections.] Connect the wires according to the diagram (3). Ensure connections are secure.
Step 4: Pole Extension and Base Attachment
[Diagram: Shows the lamp pole being extended and the base being attached to the pole.] Extend the lamp pole and attach it to the assembled base (5).
Step 5: Final Power Connection
[Diagram: Shows the power cord being connected to the base.] Connect the power cord to the base.
Operation
- Turn on power at the circuit breaker or fuse box. [power plug]
- Turn the light switch on to activate the fixture. [light switch]
