Package Contents
| Part | Description | Quantity |
|---|---|---|
| A | Fixture body with wire | 1 |
Light Source
Requires one 230V E27 40W bulb (not included). LED bulb recommended.
Care and Cleaning
Exterior Maintenance
- To clean the outside of the fixture, use a dry or slightly dampened clean cloth. Use clean water, never a solvent, to wipe the surface.
- Do not use cleaners with chemicals, solvents, or harsh abrasives. Use only a dry soft cloth to dust or wipe carefully.
Pre-Installation
Planning the Installation
Read all instructions before assembly and installation. Before starting installation or removal of a previous fixture, disconnect the power by turning off the circuit breaker or removing the fuse. To avoid damaging this product, assemble it on a soft, non-abrasive surface such as carpet or cardboard.
Tools Required
Knife [cutting tool]
Installation
Step 1: Preparation
Place the fixture body on a stable, soft, non-abrasive surface.
Step 2: Bulb Installation
Insert the recommended bulb into the socket within the fixture body. Ensure the bulb is suitable for Max 230V E27 40W.
Operation
- Turn on power at the circuit breaker or fuse box.
- Turn the light switch on to activate the fixture.
Safety Warnings
Important: Always follow these safety guidelines:
- Only use bulbs as directed on the label on the lamp.
- Turn off the lamp before replacing the bulb and wait until the bulb has cooled.
- Take special care when touching the lamp while it is lit, as it can be hot.
Further Information
For more information, visit: www.lampehuset.no
