Package Contents
Parts are not to scale:
Diagram description: Visual representation of lamp components. Part A is the fixture body, Part B is a wall expansion particle, and Part C is a self-tapping screw. A screw and wall plug are depicted.
| Part | Description | Quantity |
|---|---|---|
| A | Fixture body | 1 |
| B | Wall expansion particle | 2 |
| C | Self-Tapping screw | 2 |
Light Source
Requires one 230V E27 40W Max bulb. An LED bulb is recommended.
Care and Cleaning
Exterior Maintenance
- To clean the outside of the fixture, use a dry or slightly dampened clean cloth. Use clean water, never a solvent, to wipe the surface of the fixture.
- Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry soft cloth to dust or wipe carefully.
CAUTION
Warning:
- Only use bulbs as directed on the label on the lamp.
- Turn off the lamp before replacing the bulb and wait until the bulb has cooled. Take special care to touch the lamp when the lamp is lit. It can be hot.
Pre-Installation
Planning the Installation
Read all instructions before assembly and installation. Before starting installation of the fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. To avoid damaging this product, assemble it on a soft, non-abrasive surface such as carpet or cardboard.
Tools Required
- Cross Screwdriver [cross-screwdriver-icon]
- Flathead Screwdriver [flathead-screwdriver-icon]
- Knife [knife-icon]
- Wire Cutter [wire-cutter-icon]
- Percussion drill [percussion-drill-icon]
- Chopping bit Dia 6 mm [drill-bit-icon]
- Ladder [ladder-icon]
- Safety Goggles [safety-goggles-icon]
Installation
Step 1: Mounting the wall expansion particles and bracket in the wall
Diagram description: Illustrates attaching components to the wall. Step 1 shows inserting wall expansion particles (B) into the wall. Step 2 shows securing a bracket using self-tapping screws (C). Step 3 indicates the bracket is firmly attached.
- Insert wall expansion particles (B) into the wall.
- Secure the bracket using self-tapping screws (C).
- Ensure the bracket is firmly attached.
Step 2: Assemble the fixture onto the bracket
Diagram description: Shows the fixture body being attached to the wall bracket. Step 1 depicts connecting the fixture body (A) to the bracket. Step 2 shows securing the fixture body.
- Connect the fixture body (A) to the mounted bracket.
- Secure the fixture body.
Step 3: Insert the correct light bulb
Diagram description: Shows a light bulb being inserted into the fixture socket. The bulb specification is Max 230V E27 40W; LED bulb recommended.
Max 230V E27 40W; Recommend LED bulb.
Operation
Follow these steps to operate the lamp:
- Turn on power at the circuit breaker or fuse box.
- Turn the light switch on to activate the fixture.
