FRIHULT
Important Safety Information
Always shut off power to the circuit before starting installation work. In some countries, electrical installation work may only be carried out by an authorized electrical contractor. Contact your local electricity authority for advice.
The installation shall be carried out by an authorized electrical contractor. The luminaire must be permanently installed in the electric system and placed in the correct zone. Different materials require different types of fittings. Always choose screws and plugs that are specially suited to the material.
Installation Guide
Step 1: Prepare Fixture Base
The diagram shows the main globe component being detached from the base by twisting. Two flexible wires are indicated with an information symbol [i].
Step 2: Secure Mounting Plate
The diagram illustrates two screws being inserted and tightened into the fixture's base, likely to secure it to a mounting plate or surface.
Step 3: Mount Fixture Base
The diagram shows a mounting plate being attached to a surface with a screw. The fixture's base is then shown being positioned to attach to this plate.
Step 4: Insert Fixture Base
The diagram shows the fixture's base being inserted into the main housing of the lamp.
Step 5: Route Wires
The diagram illustrates electrical wires being fed through the internal structure of the lamp housing.
Step 6: Attach Fixture to Mounting
The diagram shows the fixture being secured to the mounting plate using two screws. A warning [!] symbol is shown next to a screw, and a crossed-out screw indicates to use appropriate fasteners for the material.
Step 7: Prepare Wire Connections
The diagram shows electrical wires being routed and prepared for connection within the fixture.
Step 8: Insert Wire Connector
The diagram shows a wire connector being inserted into its designated housing within the fixture.
Step 9: Connect Wires to Terminals
The diagram illustrates electrical wires being connected to the terminals marked 'N' (Neutral) and 'L' (Live) inside the fixture.
Step 10: Secure Wire Connector
The diagram shows the wire connector being pushed into its final secured position.
Step 11: Final Wire Connections
The diagram details the connection of the neutral (N) and live (L) wires to the respective terminals using push-in connectors.
Step 12: Complete Wire Connections
The diagram shows the final wire connection being made, with the connector fully secured.
Step 13: Install Light Bulb
The diagram shows a light bulb being screwed into the lamp socket.
Step 14: Attach Globe
The diagram shows the main globe component being twisted back onto the fixture to complete the installation.
