TÄLLBYN Pendant Lamp

Important Safety Information

Always shut off power to the circuit before starting installation work. In some countries, electrical installation work may only be carried out by an authorized electrical contractor. Contact your local electricity authority for advice.

Assembly Instructions

1. Attach the mounting bracket (part numbers 153748, 153749) to the ceiling support. Ensure one bracket is used.

   [Diagram: Shows a mounting bracket with two clips and a threaded rod, labeled '1x'. The bracket has part numbers 153748 and 153749.]

2. Connect the lamp's canopy to the socket assembly. Rotate to secure.

   [Diagram: Shows the socket assembly with a cable, and the lamp canopy being attached and rotated.]

3. Connect the electrical cable to the socket assembly. Insert wires into the appropriate terminals.

   [Diagram: Shows the socket assembly with wires being inserted into terminals.]

4. Attach the lamp shade to the socket assembly. Secure it by rotating the locking ring. [!] Caution: Do not overtighten.

   [Diagram: Shows the lamp shade being attached to the socket assembly and a locking ring being rotated. A close-up shows correct and incorrect tightening.]

5. Thread the electrical cable through the mounting bracket.

   [Diagram: Shows a hand threading the electrical cable through the mounting bracket.]

6. Secure the electrical cable within the mounting bracket using the provided clips.

   [Diagram: Shows a close-up of the mounting bracket with the cable being secured by clips.]

7. Ensure the cable is properly secured in the bracket.

   [Diagram: Shows the cable secured in the bracket with a close-up view.]

8. Hang the assembled lamp onto the ceiling hook. Adjust the cable length, ensuring 20-40 mm (25/32" - 1" 37/64) of slack. Two people may be needed for this step.

   [Diagram: Shows two people holding the lamp while it's being hung from a ceiling hook. An inset shows a measurement of 20-40 mm.]

9. Connect the electrical wires to the connector block. Ensure Line (L) and Neutral (N) wires are connected to the correct terminals.

   [Diagram: Shows a close-up of a connector block with wires being inserted, indicating L and N terminals.]

10. Push the connector firmly until it clicks into place.

    [Diagram: Shows the connector being pushed until it clicks.]

11. Connect the remaining electrical wires to the connector block.

    [Diagram: Shows wires being connected to the connector block.]

12. Push the connector firmly until it clicks into place.

    [Diagram: Shows the connector being pushed until it clicks.]

13. Secure the lamp shade onto the socket assembly. [!] Caution: Do not overtighten.

    [Diagram: Shows the lamp shade being attached and tightened onto the socket assembly.]

14. Insert the lamp into the socket.

    [Diagram: Shows a hand inserting a light bulb into the socket.]

15. Screw in the light bulb.

    [Diagram: Shows a light bulb being screwed into the socket.]