Minelab X-TERRA INTREPID Metal Detector

Controls

The control panel of the Minelab X-TERRA INTREPID features the following:

• 1. POWER ON/OFF (?): Button to turn the device on or off.
• 2. MINUS (-) / PLUS (+): Buttons used for adjusting settings, typically decreasing or increasing values.
• 3. PINPOINT (?): Button used to precisely locate the center of a detected target.
• 4. VOLUME ADJUST: Controls for adjusting the audio output volume.
• 5. SEARCH MODE: Button to select different search modes for various detection scenarios.

Quick Start

Follow these steps to begin using your detector:

1. 1. TURN ON (?): Press the Power On/Off button to activate the detector.
2. 2. WAIT (5 sec) (⏱️): Allow the detector to initialize for approximately 5 seconds.
3. 3. BEGIN DETECTING (?‍♂️): Once initialized, you can start your search.

Assembly

Assemble the Minelab X-TERRA INTREPID as follows:

1. Connect the shaft sections (parts 2, 11, 3) to form the main shaft.
2. Attach the control handle (5) and armrest (10) to the upper shaft (11).
3. Mount the search coil (9) to the lower shaft (3) using the coil mount (4).
4. Connect the search coil cable (8) to the control box (1).
5. Insert batteries (parts 13, 14, 15) into the battery compartment (7) and secure with the cover (6).

Refer to the diagrams for precise connection points and part orientation.

Safety Precautions (⚠️)

• Temperature: Do not expose the detector to extreme temperature conditions. The storage temperature range is from -20°C to +70°C (-4°F to +158°F).
• Water/Moisture: Do not expose accessories not listed as waterproof to liquid, moisture, or excessive humidity.
• Children: Do not allow children to play with the detector or accessories; small parts are a choking hazard.
• Battery Disposal (♻️): Dispose of batteries according to local regulations.

Compliance and Specifications

FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

US Responsible Party: MINELAB AMERICAS INC, 3565 Butterfield Road, Suite 121, Aurora, IL 60502, USA. Contact: ComplianceManager@minelab.com.au

EU Authorised Representative: Minelab International Ltd., Penrose One, Penrose Dock, T23KW81, Ireland. Contact: minelab@minelab.ie

EU & UKCA Declaration of Conformity: Minelab Electronics Pty Ltd declares that the radio equipment type X-TERRA VOYAGER complies with Directive 2014/53/EU and The Radio Equipment Regulations 2017. Full text of the declarations are available at: www.minelab.com/compliance

WEEE Symbol (♻️): This symbol indicates that the equipment and its electrical accessories should not be disposed of as household garbage. These items should not be disposed of as unsorted municipal waste and should be taken to a certified collection point for recycling and proper disposal. Refer to 2012/19/EU (Waste Electrical and Electronic Equipment).

Specifications