Minelab X-TERRA PRO Metal Detector Quick Start Guide

Quick Start Steps

Follow these four simple steps to begin detecting:

1. Step 1: Power On

   Assemble the detector and power it on. [Visual: Shows the assembled metal detector with coil, shaft, and control box.]

2. Step 2: Select Search Mode

   Choose the appropriate search mode for your environment. [Visual: Shows the control interface with different mode icons.]

3. Step 3: Noise Cancel

   Perform noise cancellation to optimize performance. [Visual: Shows the noise cancellation process on the display.]

4. Step 4: Detect

   Begin searching for targets. [Visual: Depicts a user actively using the metal detector in a field.]

Search Modes

The X-TERRA PRO offers several pre-set search modes:

• Park

  ? Ideal for parks, trash-filled recreational areas, and most common searches.

• Field

  ? Ideal for searching historical sites. Accommodates a very wide range of target sizes.

  Sub-modes include: General/Coin, High-end Jewelry, Coin/Artifact, High-end Coin/Artifact.

• Beach

  ?️ Suitable for all conditions with high salt content, including dry sand, wet sand, shorelines, and underwater.

  Sub-modes include: Wet Sand/Dry Sand, Underwater/Beach.

Assembly

Follow these steps to assemble your X-TERRA PRO detector:

1. [Visual: Connect lower shaft to coil.]
2. [Visual: Connect middle shaft to lower shaft.]
3. [Visual: Connect upper shaft to middle shaft.]
4. [Visual: Attach control box to upper shaft.]
5. [Visual: Connect coil cable to control box.]
6. [Visual: Adjust shaft length.]
7. [Visual: Attach armrest.]
8. [Visual: Attach battery pack.]
9. [Visual: Final assembled detector.]

Controls and Display

Familiarize yourself with the detector's controls and display:

• Ground Balance Indicator: ⛰️ [Ground Balance]
• Battery Level/Charge: ? [Battery Status]
• Discrimination Scale: [Discrimination Scale]
• Power Button: ? [Power On/Off] (Short press: Backlight ?, Long press: Flashlight)
• Sensitivity: ? [Signal Strength]
• Frequency Display: 〰️ [Frequency]
• Pinpoint Detection Indicator: ? [Target Location]
• Search Mode: [Mode Selector]
• Sensitivity and Settings Adjustment: ➕ / ➖ [Adjust Settings]
• Backlight Icon: ? [Backlight Status]
• Flashlight Indicator: ? [Flashlight Status]
• Vibration Indicator: ? [Vibration Status]
• Headphone Indicator: ? [Headphone Status]
• Wireless Audio Indicator: ? [Wireless Audio Status] (Short press: Wireless Audio On/Off, Long press: Wireless Audio Pairing)
• Depth Gauge: ? [Depth Measurement]
• Target ID Number: [Target Identification Number]
• Settings Button: ⚙️ [Settings Menu] (Short press: Scroll to next setting)
• Noise Cancel Button: ? [Noise Cancellation]
• Ground Balance Button: ⛰️ [Ground Balance Adjustment]
• Volume Adjustment: ? [Volume Control]
• Threshold Level: ? [Audio Threshold]
• Target Tones: ? [Target Tone Settings]
• Accept/Reject Button: ✔️ / ❌ [Accept/Reject Target]
• Advanced Settings Button: ?️ [Advanced Settings] (Long press: Switch to advanced settings)
• Recovery Speed: ? [Recovery Speed]
• Tone Volume: ? [Tone Volume Control]
• Tone Break: ? [Tone Break Adjustment]

Charging

The detector charges via USB. A full charge takes approximately 5-6 hours.

? [USB A Port] Use a high-quality USB charger with a minimum charging capacity of 2A at 5V. Using a low-quality charger may risk damaging the unit. Ensure your USB charger displays the following marks: CE, EAC, Intertek.