KINGSTON

Tools Required

• Drain Wrench [wrench-tool]
• Dumbbell Drain Wrench [dumbbell-wrench-tool]
• Basin Wrench [basin-wrench-tool]
• Adjustable Wrench [adjustable-wrench-tool]
• Silicone Sealant [sealant-tube-icon]
• Screwdriver [screwdriver-tool]

Installation Step:

1. Clean area around the sink drain hole and apply a bead of silicone based caulking to the underside of the drain flange and insert into drain hole from the top.
2. From below the sink slide rubber washer up onto the drain threads until it comes in contact with the sink.
3. Thread locknut by hand, make sure the drain is centered on the sink drain hole and tighten lock nut using a basin wrench, be careful not to overtighten especially if it is being installed on a porcelain or fireclay sink.
4. Secure the "P" trap to the drain using the provided compression nut and rubber gasket.

Drain Assembly Components:

• Component 1: Sink strainer grid with multiple holes
• Component 2: Drain body with threaded pipe
• Component 3: Large rubber washer
• Component 4: Large metal washer or flange
• Component 5: Small rubber washer
• Component 6: Lock nut