Fortin EVO-ALL Installation Guide for Volkswagen Jetta GLI (2011-2019)

This guide provides detailed instructions for installing the Fortin EVO-ALL module in a Volkswagen Jetta GLI with an automatic transmission.

Compatibility and Vehicle Information

Vehicle: VOLKSWAGEN Jetta GLI

Years: 2011-2018

Transmission: Automatic Transmission Only

Module: EVO-ALL

Firmware Version: Minimum 67.[04]

To update firmware and options, use the FLASH LINK UPDATER or FLASH LINK MOBILE tool (sold separately).

Vehicle Functions Supported

The following vehicle functions may be supported, depending on the vehicle's equipment:

Immobilizer bypass with TB-VW (sold separately)
T-Harness available (sold separately)
Lock
Unlock
Arm
Disarm
Tachometer
Parking Lights
Trunk - open
Door Status
Trunk Status
Hood Status *
Hand-Brake Status
Foot-Brake Status
OEM Remote monitoring

Programming Bypass Options

Program bypass option: C1 (OEM Remote status monitoring)
Program bypass option (if equipped with OEM alarm): D2 (Unlock before / Lock after)
Program bypass option (if vehicle not equipped with functional hood pin): A11 (Hood trigger output status)

Notes

The vehicle's OEM remote will operate while the engine is running.

Mandatory Installation

Hood Pin

The hood pin switch must be installed. If the vehicle can be remote started with the hood open, set function A11 to OFF.

Notice: The installation of safety elements, including the hood pin, is mandatory.

Warning: This module must be installed by a qualified technician. Incorrect connections can cause permanent damage to the vehicle.

Parts Required (Not Included)

Wire to Wire Diagram

1x TB-VW (key bypass)
1x 7.5 Amp Fuse
2x Diodes

THARNESS DIAGRAM

THARNESS THAR-VW6: 1x TB-VW (key bypass), 1x THAR-VW6
THARNESS THAR-VW2: 1x TB-VW (key bypass), 1x THAR-VW2

Stand Alone Configuration

OEM Remote Stand Alone Remote Starter: Program bypass option D1.1 (Lock, Unlock, Lock)

Program bypass option with OEM remote: C1 (OEM Remote Monitoring)

Program bypass option with RF KIT antenna: H1 to H6 (Supported RF Kits and select RF Kit)

Remote Starter Functionality

To start the vehicle:

Ensure all doors are closed.
Press the OEM remote's Lock, Unlock, Lock buttons consecutively.
The vehicle will start.

To stop the vehicle: Press the OEM remote's Lock, Unlock, Lock buttons consecutively.

Remote Starter Diagnostics (Module RED LED):

x2 flash: Brake ON
x3 flash: No tach
x4 flash: Ignition detected before start
x5 flash: Hood Open

DCRYPTOR Programming Procedure

Parts Required: FLASH LINK UPDATER, FLASH LINK MANAGER, FLASH LINK MOBILE, FLASH LINK MOBILE APP, Windows Computer or Smartphone.

Close and open the driver door.
Press and hold the programming button. Connect the 4-PIN Data-link harness. LEDs will illuminate.
Release the programming button when the Blue LED is ON. If not solid Blue, restart the process.
Connect remaining harnesses.
Turn the key to the Ignition ON/RUN position.
Press and release the programming button once. The Blue LED will turn off.
Wait for the Red LED to turn ON. Release the programming button.
Wait without touching the vehicle or module. Blue, Red, and Yellow LEDs will alternate.
Wait for the Red LED to turn ON.
Wait for Red and Yellow LEDs to slowly alternate. If Red LED flashes slowly, programming failed; restart from step 1.
Turn the key to the OFF position.
Disconnect all connectors, including the Data-Link connector.
Use the FLASH LINK UPDATER or FLASH LINK MOBILE tool to visit the DCRYPTOR menu.
After DCRYPTOR programming is complete, reconnect the Data-Link connector and all other harnesses.
Programming Complete: RED and YELLOW LEDs stay OFF.
Turn the key to the Ignition ON/RUN position.
The Yellow LED will turn OFF.
Turn the key to the OFF position.
Module is now programmed.

Note: If programming is interrupted, the vehicle may not start normally. Disconnect and reconnect the vehicle battery to correct the situation.

Optional RF-Kit Programming

Program bypass option: H2

Supported RF-KITS: H2 Fortin 2

Optional Fortin RF Kit Series 4 or Series 9 Programming: Follow on-screen instructions for the specific RF kit model.

Remote Starter / Alarm Verification Procedure

Test the remote starter. Remote start the vehicle.

	Fortin EVO-ALL Installation Guide for Volkswagen Passat (2012-2019) with Key Comprehensive installation guide for the Fortin EVO-ALL interface module in a Volkswagen Passat (2012-2019) requiring a standard key. Covers wiring diagrams, programming procedures, and remote starter functionality.
	Fortin EVO-ALL Installation Guide for Volkswagen Golf (2015-2018) Comprehensive installation guide for the Fortin EVO-ALL module with TB-VW for Volkswagen Golf models from 2015-2018. Covers wiring diagrams, programming procedures, and remote starter functionality.
	Fortin EVO-ALL Installation Guide for Volkswagen Golf (2015-2018) with Key Comprehensive installation guide for the Fortin EVO-ALL module in a Volkswagen Golf (2015-2018) models requiring a key for operation. Includes wiring diagrams, programming procedures, and functionality details.
	Fortin THAR-VW1 Installation Guide for Volkswagen Golf (2015-2018) Push-to-Start This guide provides detailed instructions for installing the Fortin THAR-VW1 remote starter and bypass module in Volkswagen Golf vehicles equipped with push-to-start ignition, model years 2015-2018. It includes wiring diagrams, programming procedures, and functionality explanations.
	Fortin EVO-ALL Installation Guide for Volkswagen Tiguan (2018) Comprehensive installation guide for the Fortin EVO-ALL universal data bypass and interface module for the 2018 Volkswagen Tiguan. Includes wiring diagrams, programming procedures, and remote starter functionality.
	Fortin EVO-ONE THAR-VW1 Installation Guide for Volkswagen Jetta (2011-2014) Comprehensive installation guide for the Fortin EVO-ONE remote starter and alarm system with THAR-VW1 harness for Volkswagen Jetta models from 2011 to 2014 with Push-to-Start ignition. Includes wiring diagrams, programming procedures, and functionality details.
	Fortin EVO-ALL THAR-GM1V2 Installation Guide for Buick Encore (2013-2016) Comprehensive installation guide for the Fortin EVO-ALL THAR-GM1V2 remote starter and bypass module for the Buick Encore 2013-2016 models. Includes wiring diagrams, programming procedures, and important warnings.
	Fortin EVO-ALL Installation Guide for Nissan Frontier Comprehensive installation guide for the Fortin EVO-ALL interface module in a Nissan Frontier (2005-2019), covering wiring, programming, and remote start functionality.