Fortin EVO-ALL Installation Guide for Volkswagen Tiguan (2018)

Vehicle Compatibility

Vehicle: VOLKSWAGEN Tiguan

Years: 2018

Compatibility Note: Only compatible with automatic transmission vehicles.

Firmware and Options

To add firmware version and options, use the FLASH LINK UPDATER or FLASH LINK MOBILE tool (sold separately).

Firmware Version: 61.[12] VW MINIMUM

Program Bypass Options

• Program bypass option (OEM Remote Stand Alone): Program the bypass option for the OEM remote stand-alone remote starter.
• Program bypass option (with OEM alarm): Program the bypass option if the vehicle is equipped with an OEM alarm.
• Program bypass option (with RF KIT antenna): Program the bypass option with an RF KIT antenna.

Option Unit Descriptions:

• C1: OEM Remote status (Lock/Unlock) monitoring.
• D2: Unlock before / Lock after (Disarm OEM alarm).
• A11: Hood trigger (Output Status).

Notes

• 1 Key required for the installation.
• The vehicle's OEM remote will operate while the engine is running.

Mandatory Installation

Hood Pin: The hood pin switch must be installed. If the vehicle can be remote started with the hood open, set function A11 to OFF.

Safety Warning: The installation of safety elements is mandatory. The hood pin and the valet switch are essential security elements and must be installed. This module must be installed by a qualified technician. Incorrect connections can cause permanent damage to the vehicle.

Parts Required (Not Included)

Wire to Wire Diagram

• 1x Vehicle key
• 1x 7.5 Amp. fuse
• 4x Diodes

Harness Diagram (T-Harness)

• THARNESS THAR-VW6: 1x Vehicle key, 1x THAR-VW6
• THARNESS THAR-VW2: 1x Vehicle key, 1x THAR-VW2

Remote Starter Functionality

To remote start: All doors must be closed. Press the OEM remote's Lock, Unlock, Lock buttons consecutively. The vehicle will start.

To remote stop: Press the OEM remote's Lock, Unlock, Lock buttons consecutively.

Diagnostics:

• x2 flash (Red LED): Brake ON
• x3 flash (Red LED): No tach
• x4 flash (Red LED): Ignition detected before start
• x5 flash (Red LED): Hood Open

Programming Procedure

1. Press and hold the programming button. Connect the 4-PIN Data-link connector (Black connector). The BLUE, RED, YELLOW and BLUE & RED LEDs will illuminate alternatively.
2. Release the programming button when the BLUE LED is ON. If the LED is not solid BLUE, disconnect the 4-Pin connector (Data-Link) and go back to step 1.
3. Insert the required remaining connectors.
4. Turn the key to the Ignition ON/RUN position.
5. Press and release the programming button once (1x). The BLUE LED will flash rapidly.
6. Turn the key to the OFF position. The BLUE LED will turn off.

The module is now programmed.

Remote Starter Warning Card

WARNING | ATTENTION: The vehicle can be started by either pressing the Lock button on the OEM remote 3 times consecutively or by a smartphone. Turn on the safety switch located under the dashboard before working on the vehicle.

Wiring Diagrams

Detailed wire-to-wire and T-harness diagrams are provided for the installation, illustrating connections for ignition, key sense, starter, CAN bus, transponder, hood pin, brake, and hazards.

Important Notices

Firmware Updates: Updated firmware and installation guides are available on the Fortin website. It is recommended to update to the latest firmware and download the latest installation guide.

Disclaimer: The information provided is a guide only. Fortin Electronic Systems assumes no liability for installation accuracy or any damages resulting from installation. The module must be installed by a qualified technician.

Technical Support

Phone: 514-255-HELP (4357) / 1-877-336-7797

Website: www.fortinbypass.com