TECNO CAMON 40 User Manual

Know Your Phone

This section provides a visual guide to the TECNO CAMON 40, identifying its key external features.

Front View:

• 1. Front camera

Side View (Right):

• 2. Volume + button
• 3. Volume - button
• 4. Power button

Back View:

• 5. NFC (Near Field Communication)

SIM Card Installation

Follow these steps to install your SIM and/or SD card:

1. Ensure your phone is powered off before proceeding.
2. Refer to the diagrams for correct SIM/SD card placement.

Dual SIM Card Installation: If your device supports dual SIM cards, install them as shown in the diagram.

Single SIM and SD Card Installation: If your device supports a single SIM card and a single SD card, install them in the direction indicated by the arrows in the diagram.

Charging the Phone

You can charge your TECNO CAMON 40 using a TECNO-approved charger or by connecting it to a computer via a USB cable (included with the phone).

Important: Use only official TECNO chargers and cables. Using unauthorized accessories may damage your phone and void its warranty.

FCC Caution

Labelling Requirements:

• This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
• Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Information to the User:

This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and may radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device causes harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the device and receiver.
• Connect the device to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Specific Absorption Rate (SAR) Information:

This mobile phone meets the government's requirements for exposure to radio waves. The guidelines are based on standards developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. The SAR limit of USA (FCC) is 1.6W/kg averaged over one gram of tissue. The TECNO CAMON 40 (Device type: CM5, FCC ID: 2ADYY-CM5) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 0.267 W/kg, and when properly worn on the body is 0.802 W/kg.

Body-worn Operation:

This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 1.0 cm must be maintained between the user's body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used with this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.

Exploded Diagram Specification

The following table lists the components of the TECNO CAMON 40 as shown in the exploded diagram: