Issue 2: THON6SN Honda Civic Tourer 2014>
Parts List
| Item | Qty | Description | Item | Qty | Description |
|---|---|---|---|---|---|
| A | 1 | Crossmember | E | 1 | VASP8 L/H Socket Plate |
| B | 2 | Handed Side Arms | F | 4 | M8 x 30 Bolts & S/P Washers |
| C | 1 | ACS1 / 9201 Swan Neck | G | 8 | M10 x 35 Bolts, 4 Nuts & 8 S/P Washers |
| D | 2 | 40mm O/D Tube x 23mm Long | H | 2 | M12 x 110 Grade 10.9 Bolts & Nyloc Nuts |
| X | 2 | M16 Black Bolt Caps | J | 2 | 15mm Spacer Plates |
| K | 1 | M16 x 110 Bolt & Nyloc Nut | |||
| L | 4 | 8 x 25 Flat Washers | |||
| M | 4 | 10 x 25 Flat Washers | |||
| N | 4 | 10 x 40 Flat Washers | |||
| P | 4 | 12 x 25 Flat Washers | |||
| R | 2 | 16 x 27 Flat Washers |
Bumper Removal
- Remove the rear bumper, six fixings along the lower edge, four fixings under plastic covers in boot opening. Remove wheel arch trims and remove the remaining two fixings. Pull out the bumper tips outward and slide bumper rearward.
- Remove the impact beam (six fixings). Pull upwards to remove. (Impact Beam is not refitted with the Towbar)
Towbar Installation
- Using Item F with Item L loosely fit Item A to the rear panel.
- Using Item K with Items R fix Item A to the Towing eye using Items D.
- Insert Items B through the Towbar end plates and the rear panel and fix to the vertical mounting points found on the lower face of each chassis member using Item G and Item N.
- Using Items G with Items M fix Items B to Item A.
- Using Item H with Item R and Item J fix Item C and Item E to Item A.
- Fully tighten all fixings ensuring the Towbar is rigid, square, central and secure.
- Cut the rear bumper as per the sketch below and refit to the vehicle.
Diagram Description
The diagram illustrates the Tow-Trust THON6SN towbar assembly for the Honda Civic Tourer 2014. It depicts the main components and their connection points to the vehicle's chassis and rear structure. The assembly includes a central crossmember (A) that spans the rear of the vehicle, with handed side arms (B) connecting to the chassis. A swan neck hitch (C) and a socket plate (E) are mounted to the crossmember. Various fasteners, including bolts (F, G, H, K), nuts, and washers (L, M, N, P, R), along with spacer plates (J), are shown and labelled according to the parts list, indicating how the towbar is secured to the vehicle's frame and towing points.
Notes
- Recommended Torque Setting for M12 Grade 10.9 -139 Nm. (For other Torque Settings see notes overleaf.)
- Nose load limits and vehicle manufacturers trailer / caravan weight limits must be observed.
