PLATSA

Important Safety Information

⚠ WARNING! Serious or fatal crushing injuries can occur from furniture tip over. To prevent tip over, this furniture must be used with the wall attachment device(s) provided. Screw(s) and plug(s) for the wall are not included. Use screw(s) and plug(s) suitable for your walls. If you are uncertain, seek professional advice. Read and follow each step of the instructions carefully.

Parts Included

• 4x Long bolts (108736)
• 4x Small plastic dowels/pegs (152059)
• 8x Wall plugs (151705)
• 8x Screws (151706)
• 2x Small screws (146113)
• 2x Round caps/covers (10005905)
• 2x Circular plates/washers (126916)
• 2x Round feet/caps (150689)
• 2x Corner brackets with screws (150688)
• 1x Metal strap/bracket (10090922)

Assembly Steps

1. Step 1: Connect frame components. Insert the cam lock bolt into one piece and secure it with the cam lock mechanism in the other piece.
2. Step 2: Slide the side panels into the grooves of the main frame.
3. Step 3: Ensure the side panels are correctly seated within the frame.
4. Step 4: Attach the back panel by sliding it into the designated grooves.
5. Step 5: Secure the assembled unit by attaching it to the wall using the provided wall plugs (8x) and screws (8x). Ensure screws and plugs are suitable for your wall type.
6. Step 6: Attach the corner brackets (2x) with screws (2x) to the base of the unit, then attach the round feet/caps (2x) to the brackets.
7. Step 7: Attach the remaining round feet/caps (2x) using the smaller screws (2x).
8. Step 8: Insert the adjustable feet into the base of the unit.
9. Step 9: Use the LÄTTHET tool (or similar) for assembly as shown.
10. Step 10: Attach the wall mounting bracket (1x) to the unit and secure it to the wall using appropriate screws and plugs (not included). Ensure the bracket is firmly attached.
11. Step 11: Connect two PLATSA units together using the metal strap (1x) and screws (2x).
12. Step 12: For stacking units, ensure they are securely connected. The maximum stacking height is 300 cm (118 7/64").
13. Step 13: Final check of connections and stability.