PLATSA Assembly Instructions

Important Safety Information

WARNING!

Serious or fatal crushing injuries can occur from furniture tip over. To prevent tip over, this furniture must be used with the wall attachment device(s) provided.

Screw(s) and plug(s) for the wall are not included. Use screw(s) and plug(s) suitable for your walls. If you are uncertain, seek professional advice. Read and follow each step of the instruction carefully.

⚠️ Always ensure furniture is securely attached to the wall to prevent tipping.

Parts Included

• 4x Screw (Part #108736)
• 4x Dowel (Part #152059)
• 8x Screw (Part #151705)
• 8x Screw (Part #151706)
• 2x Screw (Part #146113)
• 2x Cap (Part #10005905)
• 2x Cap (Part #126916)
• 2x Foot (Part #150689)
• 2x Foot Bracket (Part #150688)
• 1x Wall Bracket (Part #10090922)

Assembly Steps

Step 1: Connect two side panels to a base panel using dowels and cam locks. Insert dowels into pre-drilled holes, then insert cam lock screws into corresponding holes. Align panels and turn cam locks to secure. (Tools required: ⚙️ Screwdriver, ? Spirit Level)

Step 2: Slide the back panel into the grooves of the assembled side and base panels.

Step 3: Attach the second side panel to the base and back panel, securing with cam locks.

Step 4: Place the top panel onto the assembled unit, ensuring it aligns correctly with the side and back panels.

Step 5: Secure the top panel using screws and dowels. Insert dowels into the top edge of the side panels and then screw through the top panel into the side panels.

Step 6: Attach the feet to the base of the unit. Screw the foot brackets into the base, then screw the feet into the brackets.

Step 7: Attach the wall mounting bracket to the top rear edge of the unit using screws.

Step 8: Secure the unit to the wall using the provided wall bracket. Ensure the bracket is properly aligned with the wall and the unit. Use appropriate wall fixings (not included).

Step 9: Adjust the feet to level the unit on uneven floors.

Step 10: Connect multiple PLATSA units together. Align units side-by-side and use the connecting bolts and nuts to secure them. Insert connecting bolts through pre-drilled holes and tighten with nuts.

Step 11: Stack PLATSA units vertically. Ensure the total height does not exceed 300 cm (118 7/64").

Step 12: Secure stacked units together using the provided connecting hardware. Insert connecting bolts through the top and bottom units and tighten.

Step 13: Connect two units side-by-side using the connecting bracket and screws. Attach the bracket to the inner sides of the units and screw into place.

Step 14: Assemble a taller configuration by stacking units. Use dowels and screws to connect the upper unit to the lower unit.