PLATSA
Assembly Instructions
Important Safety Information
⚠️ WARNING!
Serious or fatal crushing injuries can occur from furniture tip-over. To prevent tip-over, this furniture must be used with the wall attachment device(s) provided.
Screws and plugs for the wall are not included. Use screws and plugs suitable for your walls. If you are uncertain, seek professional advice. Read and follow each step of the instruction carefully.
Similar warnings are provided in multiple languages within the original document.
Parts Included
- Bolt (4x) - Part number 108736
- Dowel (4x) - Part number 152059
- Screw (8x) - Part number 151705
- Screw (8x) - Part number 151706
- Cam lock screw (2x) - Part number 146113
- Cam lock (2x) - Part number 10005905
- Screw (2x) - Part number 126916
- Connector bracket (2x) - Part number 150689
- Foot (2x) - Part number 150688
- Joining bracket (1x) - Part number 10090922
Note: Wall attachment screws and plugs are not included and must be purchased separately based on your wall type.
Assembly Steps
Step 1: Connect Panels
Insert bolts (108736) into the pre-drilled holes of one panel. Align a second panel and secure it using cam locks (10005905) by turning them to lock onto the bolts.
Step 2: Insert Base/Top Panels
Slide the base and top panels into the grooves of the assembled side panels.
Step 3: Secure Panels
Push the inserted panels firmly into place to create the basic cabinet structure.
Step 4: Attach Back Panel
Slide the back panel into the designated grooves on the rear of the cabinet.
Step 5: Reinforce Structure
Use screws (151705, 151705) to further secure the cabinet structure. Ensure all panels are tightly fitted.
Step 6: Attach Feet
Screw the feet (150688) into the base of the cabinet using the provided bolts (108736).
Step 7: Prepare for Stacking
Attach connector brackets (150689) to the top of the cabinet using screws (150689). These are used to connect units when stacking.
Step 8: Join Units
To connect two PLATSA units, align them and use the joining bracket (10090922) with screws (146113) to secure them together.
Step 9: Level Unit
Adjust the feet to ensure the cabinet is stable and level on your floor. [Adjustable feet for leveling].
Step 10: Wall Attachment
Crucial Safety Step: Secure the unit to the wall using the provided bracket (126916) and cam lock (10005905). Use wall screws and plugs appropriate for your wall type (not included). Follow instructions carefully to prevent tip-over.
Stacking Units (Optional)
Multiple PLATSA units can be stacked vertically. Ensure the total height does not exceed 300 cm (118 7/64"). Use the provided connecting hardware (e.g., bolts 108736, dowels 152059) to join stacked units securely.
