Specifications
- Size: 50*34*14.5mm
- Connector: MMCX
- Display: 3 LEDs
- Weight: 29.8g
- Power Output: 250mW/500mW/1W/2W/4W
- Input Voltage: 9~36V
- Output Voltage: 5V
- Channels: 40CH
- Protocol: Tramp
LED Indicators
| LED | Description |
|---|---|
| Red | Power |
| Green | Channel |
| Blue | Band |
Button Operation
Channel Select Mode: Short press the button to enter channel setup. The green LED will flash. Select the desired channel by short pressing the button again.
Band Select Mode: Press and hold the button for 3 seconds to enter band setup. The blue LED will turn on and flash. Select the desired band by short pressing the button.
Power Select Mode: Continue to press and hold the button for 3 seconds to enter power setup. The red LED will turn on and flash. Select the desired power level by short pressing the button.
Frequency Table
| Band | CH1 | CH2 | CH3 | CH4 | CH5 | CH6 | CH7 | CH8 |
|---|---|---|---|---|---|---|---|---|
| Band A | 3320 | 3345 | 3370 | 3395 | 3420 | 3445 | 3470 | 3495 |
| Band B | 3310 | 3330 | 3355 | 3380 | 3405 | 3430 | 3455 | 3480 |
| Band C | 3490 | 3510 | 3530 | 3550 | 3570 | 3590 | 3610 | 3630 |
| Band D | 3330 | 3350 | 3370 | 3390 | 3410 | 3430 | 3450 | 3470 |
| Band E | 3170 | 3190 | 3210 | 3230 | 3250 | 3270 | 3290 | 3310 |
| Band E (OCR) | 3490 | 3510 | 3530 | 3550 | 3570 | 3590 | 3610 | 3630 |
| Band F (OCR) | 3330 | 3350 | 3370 | 3390 | 3410 | 3430 | 3450 | 3470 |
| Race Band (OCR) | 3170 | 3190 | 3210 | 3230 | 3250 | 3270 | 3290 | 3310 |
Power Levels (mW): PIT, 250, 500, 1W, 2W, 4W
Unlock Frequencies and Power Levels
To unlock all frequencies and power levels, long press the "KEY" button until the Red LED (PWR) is constantly on, then turns off, and then on again. Release the button. A flashing Red LED indicates the unlocked status, while a constant Red LED indicates the locked status.
PIT Mode On/Off
Double-click the "KEY" button to toggle PIT Mode. When the Red LED (PWR) is off, PIT mode is active. When the Red LED (PWR) is on, PIT mode is inactive. In PIT mode, the VTX outputs extremely low power.
Notes
? If a Tramp cable is connected, the button functionality will be disabled, and frequency and power adjustments will be controlled by the flight controller.
