Reaper Extreme VTX
by FOXEER
Specifications
- Size: 38*29*11.5 cm
- Connector: MMCX
- Display: 3 LEDs
- Weight: 15.2g
- Power Output: 25mW, 200mW, 500mW, 1.5W, 3W
- Input Voltage: 9-36V
- Output Voltage: 5V
- Channels: 80CH
- Remote Control Protocol: Tramp
LED Indicator Description
- Red LED: Power status
- Green LED: Channel status
- Blue LED: Band status
Button Operation
Channel Select Mode:
Short press the button to enter CHANNEL setup. The green LED will flash. Select the desired channel using short presses.
Band Select Mode:
Continue to press and hold the button for 3 seconds to enter BAND setup. The blue LED will flash. Select the desired band using short presses.
Power Select Mode:
Continue to press and hold the button for another 3 seconds to enter POWER setup. The red LED will flash. Select the desired power output using short presses.
Frequency Table
Band | CH1 | CH2 | CH3 | CH4 | CH5 | CH6 | CH7 | CH8 |
---|---|---|---|---|---|---|---|---|
Band A | 5865 | 5845 | 5825 | 5805 | 5785 | 5765 | 5745 | 5725 |
Band B | 5733 | 5752 | 5771 | 5790 | 5809 | 5828 | 5847 | 5866 |
Band E | 5705 | 5685 | 5665 | 5645 | 5885 | 5905 | 5925 | 5945 |
Band F | 5740 | 5760 | 5780 | 5800 | 5820 | 5840 | 5860 | 5880 |
Band R | 5658 | 5695 | 5732 | 5769 | 5806 | 5843 | 5880 | 5917 |
Band H | 5653 | 5693 | 5733 | 5773 | 5813 | 5853 | 5893 | 5933 |
Band L | 5333 | 5373 | 5413 | 5453 | 5493 | 5533 | 5573 | 5613 |
Band U | 5325 | 5348 | 5366 | 5384 | 5402 | 5420 | 5438 | 5456 |
Band O | 5474 | 5492 | 5510 | 5528 | 5546 | 5564 | 5582 | 5600 |
Band X | 4990 | 5020 | 5050 | 5080 | 5110 | 5140 | 5170 | 5200 |
Power Levels: 25mW, 200mW, 500mW, 1.5W, 3W
Unlock Frequencies and Power Levels
To unlock all frequencies and power levels, long press the "KEY" button until the Red LED (PWR) is constantly on, then off, then on again. Release the button. A flashing Red LED indicates the unlocked status, while a constant Red LED indicates the locked status.
PIT Mode
Double-click the "KEY" button to toggle PIT Mode on or off.
- PIT Mode ON: Red LED (PWR) is OFF.
- PIT Mode OFF: Red LED (PWR) is ON.
In PIT mode, the VTx outputs extremely low power.
Notes
If a Tramp cable is connected to the flight controller, the VTx's physical buttons will not function. Settings will be managed by the flight controller.
[Foxeer Logo]