FOXEER Reaper Extreme VTX
Brand: FOXEER
Specifications
- Size: 36*27.5*8mm
- Connector: MMCX
- Display: 3 LEDs
- Weight: 13g
- Power Output: 25mW/200mW/500mW/1W/1.8W
- Input Voltage: 9~36V
- Output Voltage: 5V
- Channels: 72CH
- Protocol: Tramp
LED Indicator Guide
LED | Description |
---|---|
Red | Power |
Green | Channel |
Blue | Band |
Button Operation
Channel Select Mode: Short click the button to enter CHANNEL setup. The green LED will be on and flash. Select the desired channel by performing short presses.
Band Select Mode: Press and hold the button for 3 seconds to enter BAND setup. The blue LED will be on and flash. Select the desired band by performing short clicks.
Power Select Mode: Press and hold the button for 3 seconds to enter POWER setup. The red LED will be on and flash. Select the desired power level by performing simple short presses.
Frequency Table
Band | CH1 | CH2 | CH3 | CH4 | CH5 | CH6 | CH7 | CH8 |
---|---|---|---|---|---|---|---|---|
Band A | 5865 | 5845 | 5825 | 5805 | 5785 | 5765 | 5745 | 5725 |
Band B | 5733 | 5752 | 5771 | 5790 | 5809 | 5828 | 5847 | 5866 |
Band E | 5705 | 5685 | 5665 | 5645 | 5885 | 5905 | 5925 | 5945 |
Band F | 5740 | 5760 | 5780 | 5800 | 5820 | 5840 | 5860 | 5880 |
Band R | 5658 | 5695 | 5732 | 5769 | 5806 | 5843 | 5880 | 5917 |
Band H | 5653 | 5693 | 5733 | 5773 | 5813 | 5853 | 5893 | 5933 |
Band L | 5333 | 5373 | 5413 | 5453 | 5493 | 5533 | 5573 | 5613 |
Band U | 5325 | 5348 | 5366 | 5384 | 5402 | 5420 | 5438 | 5456 |
Band O | 5474 | 5492 | 5510 | 5528 | 5546 | 5564 | 5582 | 5600 |
Power Levels:
Power(mW) | PIT | 25 | 200 | 500 | 1W | 1.8W |
---|---|---|---|---|---|---|
Unlock Frequencies and Power Levels
To unlock all frequencies and power levels, long press the "KEY" button until the Red LED (PWR) is constant on. Then, observe it turn off and then on again. Release the button at this point. A flashing Red LED indicates the unlocked status, while a constant Red LED indicates the locked status.
PIT Mode On/Off
Double-click the "KEY" button to toggle PIT Mode on or off. When the Red LED (PWR) is off, PIT mode is active. When the Red LED (PWR) is on, PIT mode is inactive. In PIT mode, the VTX outputs an extremely low power level.
Notes
If a Tramp cable is connected, the button controls will not function. Frequency and power adjustments cannot be made; the connected flight controller will manage these settings.