DEWALT DXMA1901148

Jobsite Pro Wearable Speaker Instruction Manual

Jobsite Pro Wearable Speaker Instruction Manual

⚠ WARNING: TO REDUCE THE RISK OF INJURY, USER MUST READ ALL INSTRUCTIONS BEFORE OPERATING THIS PRODUCT

SAVE THESE INSTRUCTIONS

Thank you for purchasing the Jobsite Pro Wearable Speaker.

With this speaker, you can:

• Enjoy convenient, wireless, hands-free calls
• Control wireless music
• Switch between calls and music

Package Contents

• Jobsite Pro Wearable Speaker
• Type C Charging Cable
• 2 Detachable Mounting Magnets
• User Manual

Diagram of the DEWALT Jobsite Pro Wearable Speaker, showing its front view with a speaker grille, plus/minus buttons, and the DEWALT logo.

COMPONENTS AT A GLANCE

Jobsite Pro Wearable Speaker:

• Speaker
• On/Off Button
• Volume Controls
• Microphone
• Type C Charge Port
• Clip
• Detachable Mounting Magnet

Front view of the speaker, labeled with numbers for components: 1. Speaker, 2. On/Off Button, 3. Volume Controls (+/-), 4. Microphone, 5. Type C Charge Port. Back view of the speaker, showing 6. Clip, and 7. Detachable Mounting Magnet.

CHARGER CONNECTOR CABLE:

• Type C to USB

Diagram of a Type C to USB charging cable, labeled 1. Type C to USB.

DEFINITIONS: SAFETY GUIDELINES

The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to these symbols.

• ⚠ DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
• ⚠ WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
• ⚠ CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
• ⚠ NOTICE: Indicates a practice not related to personal injury which, if not avoided, may result in property damage.

• ⚠ WARNING: DO NOT leave speaker in any location with excessive heat.
• ⚠ WARNING: DO NOT charge or use the battery in explosive atmospheres, such as in the presence of flammable liquids, gases or dust.
• ⚠ WARNING: DO NOT modify the battery in any way to fit a non-compatible charger as the battery may rupture causing serious personal injury.
• ⚠ WARNING: DO NOT splash or immerse in water or other liquids.
• ⚠ WARNING: DO NOT store or use the speaker in locations where the temperature may reach or exceed 105° F (40° C) (such as outside sheds or metal buildings in summer). For best life, store speaker in a cool, dry location. The speaker should not be disposed of as municipal solid waste. To recycle it, contact your local hazardous waste processor or contact Call 2 Recycle® on their website, call2recycle.org, or by phone at 877-273-2925 to find the nearest drop-off location for lithium-polymer batteries.
• ⚠ WARNING: Burn hazard. Battery liquid may be flammable if exposed to spark or flame.
• ⚠ WARNING: Fire hazard. Never attempt to open the battery pack for any reason. If the battery pack is cracked or damaged, do not insert the charging cable. Do not crush, drop or damage the battery. Do not use the speaker if it has received a sharp blow, been dropped, run over or damaged in any way (e.g. pierced with a nail, hit with a hammer, stepped on).

Damaged batteries should be returned to a service center for recycling.

GETTING STARTED

CHARGE THE SPEAKER

Connect the Type C end of the charging cable into the speaker and the USB end into a power source. Make sure the speaker is fully charged before using it for the first time.

*Charger sold separately.

⚠ WARNING: ONLY CHARGE with certified USB adapter DC5V/0.5A

PAIR THE SPEAKER WITH YOUR BLUETOOTH DEVICE

Press and hold the speaker's ON/OFF button for 2 seconds to turn the speaker on. If not previously paired, the speaker will automatically enter pairing mode. If the speaker has been previously paired, it will automatically enter pairing mode after 20 seconds of reconnecting timeout.

Alternatively, if the speaker is turned off, you can press and hold the ON/OFF button for 6 seconds to enter pairing mode.

• When turning on the speaker, you will hear, “POWER ON - Battery HIGH (or MEDIUM or LOW)-Pairing.” While in pairing mode, the speaker's LED light will flash red and blue. If unable to connect to a previously paired device after 20 seconds, the speaker will remain in pairing mode and will automatically turn off after 3 minutes of unsuccessful connection.
• Turn on the Bluetooth function of your Bluetooth device and pair the speaker with your Bluetooth device.
• When successfully connected to a phone or other Bluetooth device, the speaker's blue LED light will stay on for 1 second and you will hear, “Your device is connected”.

THE FOLLOWING DIRECTIONS SHOW YOU HOW TO FIND THE SPEAKER ON BLUETOOTH DEVICE

Turn on the Bluetooth function of your Bluetooth device and select “DEWALT WEARABLE SPEAKER”. Enter the speaker's password "0000" if prompted. For Bluetooth devices featuring Bluetooth 3.0 or higher, no need to enter a password.

PAIR THE SPEAKER WITH ANOTHER BLUETOOTH DEVICE

If you have another Bluetooth device that you want to pair with the speaker, make sure the Bluetooth function in any other previously paired or connected devices are turned off. You will hear, “Your device is disconnected.” Then follow the steps in "PAIR THE SPEAKER WITH YOUR BLUETOOTH DEVICE."

CONNECT THE SPEAKER TO YOUR BLUETOOTH DEVICE

Turn on the Bluetooth function of your Bluetooth device. Press and hold the speaker's ON/OFF button for 2 seconds to turn the speaker on. The speaker will search for the previously connected Bluetooth device and reconnect to it automatically. If the last connected device is not available, the speaker will search and reconnect to the next most recently connected device. If no device is found, the speaker will automatically turn off after 3 minutes.

CONTROLS

To turn speaker ON:

Press and hold the ON/OFF button for 2 seconds.

To turn speaker OFF:

Press and hold the ON/OFF button for 3 seconds.

MANAGE YOUR MUSIC:

To play or pause music: Press the ON/OFF button once

• Forward (next song): Press and hold “+” button for 1 second
• Volume increase: Press "+" button
• Backward (previous song): Press and hold "-" button for 1 second
• Volume decrease: Press "-" button

CALL CONTROL

USE THE ON/OFF BUTTON

• Answer/Hang up: Press the ON/OFF button
• Reject incoming call: Press and hold the ON/OFF button for 1 second
• Switch caller during call: Double-click the ON/OFF button
• Voice Control - Siri/Google: Double-click the ON/OFF button

LED INDICATOR - USING SPEAKER

• Speaker is powered on: The Red and Blue LED flashes 1 second
• Speaker is pairing to a Bluetooth device: The Red and Blue LED flashes alternately
• Speaker is connected to a Bluetooth device: The Blue LED stays on for 1 second
• Speaker is powered on and not connected to a Bluetooth device: The Red and Blue LED flashes. If no connection can be made, the speaker will power itself off after 3 minutes.

LED INDICATOR - CHARGING SPEAKER

• 100% power = Green LED light stays on until cable is disconnected
• 80% - 99% power = Green LED light flashes
• 20% - 80% power = Blue LED light flashes
• 0% - 20% power = Red LED light flashes

LOW BATTERY LEVEL:

The Red LED light will flash 2 times per second and you will hear the "battery low” tone once every minute.

Speaker features an IP56 rating for protection against dust and water.

FACTORY RESET

1. Long press the ON/OFF button for 6 seconds on turned off device to enter pairing mode.
2. Once in pairing mode, double click the ON/OFF button to reset. You will hear a beep and the red and blue lights will flash 5 times simultaneously.

Note: If your speaker was previously paired, be sure to "Forget this device” or “Unpair” in your Bluetooth device's “paired devices” list before resetting.

TECHNICAL DATA - SPEAKER

• Music time: Up to 10 Hours
• Talk time: Up to 8 Hours
• Standby time: >10 Days
• Charging time: Approximately 1.5 Hours
• Rechargeable Li-ion battery: 3.7V 560 mAh
• Bluetooth version: 5.1

Compatible Bluetooth profiles:

• HFP
• HSP
• A2DP
• AVRCP

Supported audio codec: SBC

Operating range: 10 Meters (33 Feet)

IMPORTANT SAFETY INSTRUCTIONS FOR ALL RECHARGEABLE BATTERY PACKAGING

The battery is not fully charged out of the box. Before using the speaker, read the safety instructions below and then follow the charging procedures outlined.

Do not incinerate the battery module even if it is severely damaged or is completely worn out. The battery can explode in a fire. Toxic fumes and materials are created when lithium batteries are burned. If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte is composed of a mixture of liquid organic carbonates and lithium salts. Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention. This speaker is splash and water resistant and was tested under controlled laboratory conditions with a rating of IP56 under IEC standard 60529. Splash and water resistance are not permanent conditions and resistance might decrease as a result of normal wear. Do not attempt to charge wet speaker. To dry your speaker, tap it gently against your hand with the port cover open to remove excess liquid. Leave your speaker in a dry area with some airflow. Placing your speaker in front of a fan blowing cool air directly onto the speaker might help the drying process. Liquid damage is not covered under warranty.

LIMITED LIFETIME WARRANTY

We're here to help. If you are not satisfied with this product or have questions on how to use it, please contact us. YOU DO NOT NEED TO CONTACT THE RETAILER. Please contact one of our service representatives, using the contact info listed below. Please provide the product number when contacting us.

PLEASE CALL CUSTOMER SERVICE: 888-480-9885,

8:00 a.m.-5:00 p.m. PT, Monday - Friday, or e-mail us using: dewaltinfo@efilliate.com

E-filliate Inc.
11321 White Rock Road
Rancho Cordova, CA 95742 USA

Any controversy or claim against E-filliate Inc. and/or Affiliated Entities shall be settled by arbitration administered by the American Arbitration Association (“AAA”) in accordance with its Consumer Arbitration Rules (“AAA Rules"). Unless otherwise agreed, any arbitration hearing(s) will take place in the city and state in which you reside. Judgment on the award rendered by the arbitrator(s) may be entered in any court having jurisdiction thereof.

STORAGE RECOMMENDATIONS

1. The best storage place is one that is cool and dry, away from direct sunlight and excess heat or cold.
2. For long storage, it is recommended to store the speaker in a cool dry place for optimal results.

Compliance Information

Part No. DXMA1901148 © 2022 Stanley Black & Decker, Inc.

FCC ID: 2ADH6-1901148 DID: D058327

DEWALT® and the DEWALT Logo are trademarks of the DEWALT Industrial Tool Co., or an affiliate thereof and are used under license. The yellow/black color scheme is a trademark for DEWALT power tools & accessories. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Manufactured by E-filliate Inc.
11321 White Rock Rd.
Rancho Cordova, CA 95742 USA

FCC Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.