BAGGEBO
Design and Quality IKEA of Sweden
⚠️ WARNING! Serious or fatal crushing injuries can occur from furniture tip over. To prevent tip over this furniture must be used with the wall attachment device(s) provided. Screw(s) and plug(s) for the wall are not included. Use screw(s) and plug(s) suitable for your walls. If you are uncertain, seek professional advice. Read and follow each step of the instruction carefully.
Parts List
- 1x Metal wall bracket (Part #106989)
- 1x Screw (Part #109041)
- 2x Washer (Part #100823)
- 1x Allen key (Part #100006)
- 10x Long screw (Part #100229)
- 12x Wooden dowel (Part #101345)
- 4x Plastic guide/clip (Part #122628)
- 1x Plastic insert/foot (Part #105493)
- 14x Nail (Part #319503)
- Note: Wall screws and plugs are not included and must be purchased separately, suitable for your wall type.
Assembly Steps
Step 1
Attach the metal wall bracket (1x Part #106989) to one of the side panels using 1x screw (Part #109041) and 1x washer (Part #100823). Ensure the bracket is oriented correctly as shown.
Step 2
Insert 12x wooden dowels (Part #101345) into the pre-drilled holes on the edges of the three horizontal panels (likely shelves and top/bottom).
Step 3
Connect two side panels to the back panel. Align the dowels from the side panels with the holes in the back panel and press them together. 4x dowels are used in this step.
Step 4
Attach another horizontal panel (likely a shelf or bottom panel) to the structure. Align the dowels with the corresponding holes and press into place. 2x dowels are used.
Step 5
Use the Allen key (Part #100006) to insert 5x long screws (Part #100229) through the designated holes to secure the main frame of the unit.
Step 6
Slide in the remaining horizontal panel (likely a shelf or back panel) into the grooves or slots provided. An arrow indicates the direction of insertion.
Step 7
Secure the unit further by inserting 5x long screws (Part #100229) through the pre-drilled holes on the outer panels.
Step 8
Turn the unit upside down. Attach the 1x plastic insert/foot (Part #105493) to the bottom panel using 14x nails (Part #319503) and a hammer ?️. Ensure they are evenly spaced.
Step 9
Attach the 4x plastic guides/clips (Part #122628) to the outer edges of the side panels using a hammer ?️. These likely help with alignment or further securing.
Step 10
Turn the unit upright. Attach the wall mounting bracket assembly (from Step 1) to the top rear of the unit using 1x screw (Part #100823). This bracket is used to secure the unit to the wall.
