IKEA BAGGEBO Bookshelf Assembly Instructions

Important Safety Information

⚠️ WARNING!

Serious or fatal crushing injuries can occur from furniture tip over. To prevent tip over, this furniture must be used with the wall attachment device(s) provided.

Screws and wall plugs for the wall are not included. Use screws and plugs suitable for your walls. If you are uncertain, seek professional advice. Read and follow each step of the instruction carefully.

Parts Included

• 10x Screw (Part #100229)
• 20x Dowel (Part #101345)
• 2x Screw (Part #109041)
• 4x Washer (Part #100823)
• 1x Allen Key (Part #100006)
• 1x Plastic Holder (Part #105493)
• 4x Plastic Clip/Fastener (Part #122628)
• 1x Bag of Nails (Part #319503)
• 2x Wall Bracket (Part #106989)

Assembly Steps

1. Step 1: Lay out two side panels. Attach 4x plastic clips (Part #122628) to the inner side of one panel using a hammer.
2. Step 2: Insert 10x dowels (Part #101345) into the designated holes on the side panels.
3. Step 3: Attach the top and bottom panels to one side panel using 5x screws (Part #100229) and the Allen key (Part #100006).
4. Step 4: Attach the second side panel to the assembled structure, aligning the dowels with the corresponding holes.
5. Step 5: Secure the frame by inserting 5x screws (Part #100229) into the remaining holes.
6. Step 6: Mark the positions for the shelves using a pencil.
7. Step 7: Slide the back panel into the grooves. Secure the back panel using the central plastic holder (Part #105493) and the bag of nails (Part #319503).
8. Step 8: Insert shelf pins into the pre-drilled holes on the inside of the side panels at your desired shelf heights. (Diagrams show part #101221, likely shelf pins).
9. Step 9: Place the shelves onto the inserted shelf pins.
10. Step 10: Mark the position for the wall attachment bracket on the top rear of the unit using a ruler and pencil.
11. Step 11: Attach the wall bracket (Part #106989) to the top rear of the unit using 2x screws (Part #109041) and 2x washers (Part #100823).
12. Step 12: Position the bookshelf against the wall where you intend to place it.
13. Step 13: Secure the unit to the wall by attaching the wall bracket (Part #106989) to the wall. Use appropriate screws and wall plugs suitable for your wall type (not included). The diagram shows 2x screws (Part #100823) being used for wall attachment.