BAGGEBO Shelving Unit

Safety Warnings

• ⚠️ Warning: Children have died from furniture tipover. To reduce the risk of furniture tipover:
• ALWAYS install the provided anti-tip device.
• NEVER place a TV on this product.
• NEVER allow children to stand, climb, or hang on any drawers, doors, or shelves.
• NEVER open more than one drawer at a time.
• Place heaviest items in the lowest drawers.

Assembly Instructions

Read and follow each step of the instruction carefully.

General Assembly Guidance

Tools Required: Screwdriver.

⚠️ Tip-over Hazard: Secure furniture to the wall using the provided anti-tip device to prevent serious injury or death from tip-over.

?? Do not place televisions on this unit.

?? Prevent children from standing, climbing, or hanging on the unit.

Assemble on a soft surface, such as a carpet, to prevent scratching the product.

Ensure parts are correctly aligned before assembly. Do not force parts together.

If you are unsure about any step, refer to the detailed instructions or contact IKEA customer support.

Assembly Steps

Parts Included

• 4x Bolts (Part #10003068)
• 38x Screws (Part #10119123)
• 2x Brackets (Part #100827)
• 2x Brackets (Part #10062215)

Step 1

Attach the two side frames to the back panel. Use 4x screws (Part #10119123) for this step, with 2 screws securing each side frame to the back panel.

Step 2

Connect the first set of horizontal shelf supports to the side frames. Use 6x screws (Part #10119123) to attach the supports for the lower shelves.

Step 3

Attach the second set of horizontal shelf supports. Use 8x screws (Part #10119123) to attach the supports for the upper shelves.

Step 4

Secure the shelves to the frame. Use 4x screws (Part #10119123) to fix the shelves in place.

Step 5

Attach the bottom supports to the base of the unit. Use 4x bolts (Part #10003068) for this step.

Step 6

Install the anti-tip brackets to the top of the unit. Attach each bracket (Part #100827 and #10062215) using 2x screws (Part #10119123) per bracket, totaling 4x screws.

Step 7

Secure the unit to the wall using the anti-tip device. Attach the bracket to a wall stud or use appropriate wall anchors (not included) and connect it to the unit as shown in the diagram.