Aviancé HD76549 Lighting Fixture Assembly & Installation Instructions

The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. Model: HD76549

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. (ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.)

Assembling the Fixture (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
3. Determine the desired hanging height. Slide the electrical wires through the tubes (D)/(C)/(B) and canopy (A).
4. Raise the tube (D)/(C)/(B) and canopy (A) to the pipe thread in order, then by turning it clockwise until tight.
5. Thread the two mounting screws into the pre-drilled holes in the Mounting plate, spaced the same distance apart as the holes in the canopy (A). Attach the Mounting plate to the Junction Box with the two Junction Box screws as shown. The side of the Mounting plate marked "GND" must face outwards.
6. While holding the fixture lamp towards the ceiling, connect the electrical wires as shown in Fig.2, making sure that all wire nuts are secured. You may have to wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise, connect the fixture's ground wire directly to the Mounting plate with the green screw provided. After wires are connected, tuck them carefully inside the Junction Box.
7. Raise the canopy (A) onto the Junction box, aligning screws on the mounting plate with mounting holes in the canopy and lock it securely with the column nuts.
8. WARNING: RETURN THE ARMS TO THE VERTICAL POSITION, THE END OF THE LAMP HOLDER MUST BE UPWARD. ARMS ARE NOT FULLY ROTATABLE!
9. Install the light bulbs (Not included) in accordance with the fixture specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!

Your installation is now complete. Return power to the junction box and test the fixture.

Figure 1: Assembly Diagram Components

• Supply wire
• Fixture Ground Wire
• Fixture wire
• Junction Box (Not included)
• Supply Ground Wire
• Mounting plate
• Mounting screw
• Box screw
• A: Canopy
• Column nut
• B, C, D: Tubes (with specified lengths like D0.5"*L6" 1PC, D0.5"*L12" 1PC, D0.5"*L18" 1PC)
• E: Fixture Base/Arm Structure

Figure 2: Wiring Connections

• FIXTURE WIRES: Black or Smooth
• HOUSE WIRES: Black (Hot)
• FIXTURE WIRES: White or Ribbed
• HOUSE WIRES: White (Neutral)
• FIXTURE WIRES: Bare Copper (Ground)
• HOUSE WIRES: Green or Bare Copper (Ground)

Thank you for purchasing an Aviancé product. Need assistance with parts or assembly? Please email customer service at: info@aviancelighting.net

©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING, INC. DOC202503HD76501