Aviance HD81062 Lighting Fixture Assembly & Installation Instructions
The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.
Important Safety Information
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
Assembling the Fixture (Fig.1)
- Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
- Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
- Attach the mounting plate to the Junction Box with the two junction box screws as shown. The side of the mounting plate marked "GND" must face out. The junction box is not included.
- By measuring, determine correct cord length needed for proper hanging height, then lock it securely with small screw(C). NOTE: slide cord clip to the proper position, then you may cut the cord to desired length.
- While holding the lamp body towards the ceiling, connect the electrical wires as Shown in Fig.2, making sure that all wire nuts are secured. You may have to wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise connect fixture's ground wire directly to the mounting plate with the green screw provided. After wires are connected, tuck them carefully inside the Junction Box.
- Install canopy (A) onto the junction box, aligning screw hole on mounting plate with mounting holes in canopy and lock it securely with the screws (B).
- NOTE: THE CANOPY(A) AND SHADE(D) OF THE PRODUCT MAY VARY.
- Install the light bulb (not included) in accordance with the fixture's specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!!
Your installation is now complete. Return power to the junction box and test the fixture.
Figure 1: Fixture Assembly Diagram
Diagram shows the assembly process of the lighting fixture. Key components labeled include Junction Box (not included), Mounting plate, Box Screw, Green Screw (GND), Fixture parts A, B, C, D, and a Cord clip.
The diagram also illustrates different styles of shades (D) that may be included with the product.
Figure 2: Wiring Connections
This figure illustrates the wiring connections between the fixture wires and the house wires.
- Fixture Wires: Black (Hot), White (Neutral), Green Thread (Ground)
- House Wires: Black (Hot), White (Neutral), Green or Bare Copper (Ground)
Connections should be made by matching wire colors and securing with wire nuts. Ground wire should be connected to the ground screw on the mounting plate or directly to the mounting plate if no ground screw is present.
Customer Support
Thank you for purchasing an AVIANCE product. Need assistance with parts or assembly? Please email customer service at: info@aviancelighting.net
