Anker SoundCore 2 Owner's Manual

Safety Instructions

• Avoid dropping.
• Do not disassemble.
• Avoid extreme temperatures.
• Use original or certified cables.
• Do not use any corrosive cleaner/oil to clean.
• Do not use the device outdoors during thunderstorms.
• Do not expose batteries to high heat such as direct sunlight, fire, etc.

Notice

CE Mark: This product complies with the radio interference requirements of the European Community.

Recycling Symbol (Waste Bin with Cross): This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio / TV technician for help.

RF Warning Statement

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

IC Notice to Canadian Users

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) L' appareil ne doit pas produire de brouillage; (2) L' appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d' en compromettre le fonctionnement.

CAN ICES-3 (B) / NMB-3 (B)

This Class B digital apparatus complies with Canadian ICES-003 (Cet appareil numérique de la Classe B conforme à la norme NMB-003 du Canada).

The following importer is the responsible party:
Company Name: Fantasia Trading LLC
Address: 9155 Archibald Avenue, Suite 202, Rancho Cucamonga, CA, 91730, US
Telephone: +1 (800) 988 7973

Declaration of Conformity

This product complies with the radio interference requirements of the European Community. Hereby, Anker Innovations Limited declares that the radio equipment type A3105 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at www.soundcore.com

BT Maximum output power: 7.3dBm
BT Frequency band: 2.4G band (2.4000GHz-2.4835GHz)

Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong

Trademark

The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by Anker Innovations Limited. is under license. Other trademarks and trade names are those of their respective owners.

CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS

Charge Your SoundCore

A diagram shows a USB-C cable connecting to the SoundCore 2 speaker, with a charging indicator light.

To preserve battery lifespan, fully charge at least once every 45 days.

Turn on / off

A diagram shows the power button on the speaker.

Bluetooth Pairing

A diagram illustrates a smartphone with Bluetooth enabled, pairing with the SoundCore 2 speaker within 1 meter.

When turned on, SoundCore will automatically connect to the last connected device if available. If not, SoundCore will enter pairing mode.

Connect via AUX

A diagram shows a laptop connected to the SoundCore 2 speaker via an AUX cable.

True Wireless Stereo Pairing Mode

Double flashing blue: True Wireless Stereo Pairing Mode

With True Wireless Stereo technology, you can pair your SoundCore 2 with another SoundCore 2 to explore the best sound effects with left and right sound channels separated on both speakers.

* SoundLine AUX cable sold separately

To return to Bluetooth mode, remove the AUX cable from your SoundCore.

Controls

Specifications

Specifications are subject to change without notice.