Safety Instructions
- Avoid dropping.
- Do not disassemble.
- Avoid extreme temperatures.
- Use original or certified cables.
- Do not use any corrosive cleaner/oil to clean.
- Do not use the device outdoors during thunderstorms.
- Do not expose batteries to high heat such as direct sunlight, fire, etc.
Notice
Ⓨ This product complies with the radio interference requirements of the European Community.
♻ This symbol indicates that the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health, and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where the product was purchased.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio / TV technician for help.
RF Warning Statement
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
IC Notice to Canadian Users
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) L'appareil ne doit pas produire de brouillage; (2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
CAN ICES-3 (B) / NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003 (Cet appareil numérique de la Classe B conforme à la norme NMB-003 du Canada).
The following importer is the responsible party:
Address: 9155 Archibald Avenue, Suite 202, Rancho Cucamonga, CA, 91730, US
Telephone: +1 (800) 988 7973
Declaration of Conformity
This product complies with the radio interference requirements of the European Community. Hereby, Anker Innovations Limited declares that the radio equipment type A3105 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.soundcore.com.
BT Maximum output power: 7.3dBm
BT Frequency band: 2.4G band (2.4000GHz-2.4835GHz)
Anker Innovations LimitedRoom 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong
Trademark
Ⓡ Bluetooth®
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by Anker Innovations Limited. is under license.
Other trademarks and trade names are those of their respective owners.
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
Charge Your SoundCore
Connect the speaker to a power source using a USB cable. The charging indicator light shows the battery status:
- Flashing red: Low battery
- Steady red: Charging
- Steady white: Fully charged
To preserve battery lifespan, fully charge at least once every 45 days.
Turn On / Off
Press the power button once to turn ON (indicator light turns steady white).
Press and hold the power button for 1 second to turn OFF (indicator light turns off).
Bluetooth Pairing
To enter pairing mode:
- Press the Bluetooth button once (flashing blue light).
- To un-pair a connected device and re-enter pairing mode, press and hold the Bluetooth button for 2 seconds.
Once paired, the indicator light will be steady blue.
When turned on, SoundCore 2 will automatically connect to the last connected device if available. If not, it will enter pairing mode.
True Wireless Stereo Pairing Mode
With True Wireless Stereo technology, two SoundCore 2 speakers can be paired to explore the best sound effects with left and right sound channels separated on both speakers. The indicator light will double flash blue during this mode.
Connect via AUX
Connect an AUX cable (SoundLine AUX cable sold separately) to the speaker's AUX port.
To return to Bluetooth mode, remove the AUX cable from the SoundCore 2.
Controls
| Action | Function | Indicator |
|---|---|---|
| Press ▶ (Play/Pause) | Play / Pause | |
| Double press ▶ (Play/Pause) | Skip forward | |
| Press +/- | Volume up / down | |
| Press ☎ (Call) | Answer / End call | |
| Press and hold ☎ (Call) for 1 second | Reject call | |
| Press ☎ (Call) during a call | Put current call on hold and answer incoming call | |
| Press ☎ (Call) during a call | Switch between held call and active call | |
| Press and hold ☎ (Call) for 1 second during a call | Transfer a call between speaker and mobile phone | |
| Steady blue light (Call button) | On a call | |
| Flashing blue light (Call button) | Incoming call | |
| Press and hold 🎤 (Microphone) for 1 second | Activate Siri / other voice control software |
Specifications
Specifications are subject to change without notice.
| Feature | Detail |
|---|---|
| Input | 5V=2A |
| Play time (varies by volume level and content) | Up to 24 hours |
| Audio output | 12W+ |
| Impedance | 4 Ω |
| Range | 20 m / 66 ft |
| Size | 168 x 47 x 56 mm / 6.6 x 1.9 x 2.2 in |
| Charging time | 3 hours |
| Driver (full range) | 1.5" x 2 |
| Frequency response | 70 Hz - 20 KHz |
| Bluetooth version | V5.0 |
| Waterproof rating | IPX 7 |
| Weight | 414 g / 14.6 oz |
