PAX Wardrobe Assembly

Product Information

Brand: IKEA

Product Name: PAX Wardrobe System

Document Type: Assembly Instructions

Tools Required

The following tools are recommended for assembly:

• Screwdriver ?
• Hammer ?
• Spirit Level
• Ladder ?
• Clamp
• Drill with Ø 5 mm (1/4") drill bit
• Tape Measure

Parts List

Assembly Steps

Lay two panels on a protective surface. Insert 8x dowels (101375) into pre-drilled holes. Attach cam locks (100751) to panels, then attach more cam locks (100751) to another panel, securing with screws (101375).

Insert dowels (110618, 110617) into side panels. Attach top and bottom panels using screws (101375). Insert dowels (101375) into side panels.

Guidance on lifting and handling tall panels:

• When lifting panels vertically, ensure a height of approximately +205 cm (+80 3/4").
• Warning: ⚠️ When lifting panels, ensure the height is between 202-205 cm (79 5/9" - 80 3/4"). Avoid climbing on unsecured units.
• Use a ladder and tape measure for accurate height checks.
• Ensure the unit is placed securely against the wall at the correct height (+205 cm / +80 3/4").
• Do not place the unit higher than 202-205 cm (79 5/9" - 80 3/4") without proper securing.

Place a panel and insert 1x screw (101375) into pre-drilled holes.

Attach side panels using 2x screws (100229) and bracket (195701) for each connection.

Attach back panels using 2x screws (100229) and bracket (195701) for each connection.

Insert shelf supports (10093081/10093082) into the pre-drilled holes on the side panels.

Attach the top panel using 6x screws (100229) and bracket (195701).

Insert 16x shelf supports (10093081, 10093082) into the pre-drilled holes.

Two people are required to lift and position the assembled unit.

Secure the unit to the wall. Use a drill and screws (1x) at a height of 202-205 cm (79 5/9" - 80 3/4").

Attach hinges to the unit using 2x screws (100229) and bracket (195701) for each hinge.

Attach hinges to the door using 2x screws (100229) and bracket (195701) for each hinge.

Attach shelf supports (100229) to the unit.

Slide the back panel into place, following the indicated direction with arrows.

Secure the back panel using 6x screws (100229) and bracket (195701).

Insert 16x shelf supports (10093082, 10093081) into the pre-drilled holes.

Secure the unit to the wall using 2x screws. Warning: ⚠️ Ensure correct placement; incorrect placement is indicated by a cross ❌.

Attach shelf supports (101558) using 4x screws (115344).

Insert shelves by placing them onto the 4x shelf supports (101558).

Attach top and bottom connectors (122972) using 2x screws (115345) for each connection.

Drill pilot holes in the main wardrobe frame using a Ø 5 mm (1/4") drill bit.

Attach hinges to the main wardrobe frame using 2x screws (100229) and bracket (195701) for each hinge.

Attach door hinges using 4x screws (100644) and cam locks (100402).

Attach 8x cam locks (10080579) to the unit.

Secure shelves using 2x shelf supports (10124988) for each shelf.

Attach the top panel using 4x screws (151706).

Attach the top panel using 4x screws (151705). Ensure a height of 58 cm (22 7/8").