Zyxel WX3100-T0 Dual-Band Wireless AX1800 Gigabit Extender

Package Contents

• Device
• Power Adapter
• Ethernet Cable
• Quick Start Guide

Support Information

For online help, configuration assistance, and safety warnings, visit: https://zyxelsp.com/WX-Series

EU Importer: Zyxel Communications A/S, Gladsaxevej 378, 2. th. 2860 Søborg, Denmark

UK Importer: Zyxel Communications UK Ltd., Old Row Court, Rose Street, Wokingham, RG40 1XZ, United Kingdom (UK)

US Importer: Zyxel Communications, Inc., 1130 North Miller Street Anaheim, CA 92806-2001

General Support: https://www.zyxel.com/service-provider/global/en/tech-support

Declaration of Conformity: Available online.

Safety Warnings: Available online.

Setting Up the Device

Step 1: Attach the bracket to the bottom of the Device as shown. Place the Device where you want to extend your wireless network.

Step 2: Plug in the power adapter and turn on the Device. Wait for about 2 minutes. The Power LED lights up steady green. ? Wait until the power LED turns steady green.

Note: Avoid contact with liquid; handle with care.

MPro Mesh Network Scenario 1: With MPro Mesh Router

This scenario applies if you have a Zyxel router that supports MPro Mesh. If not, refer to Network Scenario 2.

Step 1: Use the included Ethernet cable to connect the Device LAN port to the MPro Mesh Router LAN port. Wait until the POWER and LINK LEDs are steady green.

Step 2: Unplug the Ethernet and power cable from the Device.

Step 3: Place the Device where you want to extend your wireless network.

Step 4: Plug in the power adapter. Make sure your LINK LED is steady green. Move the Device closer to the MPro Mesh Router if the LINK LED is red.

To add more extenders to your network, repeat from step 1.

Note: You do not need to plug in the Ethernet cable in this step.

4 LEDs Indicator Table

MPro Mesh Network Scenario 2: With Non-MPro Mesh Router and Two Devices

Step 1: Use the included Ethernet cable to connect the first Device (Device-1) LAN port to the Non-MPro Mesh Router LAN port. Wait until the POWER and LINK LEDs are steady green. ? Note: Do not unplug the Ethernet cable connecting the Device-1 and Non-MPro Mesh Router.

Step 2: Use another Ethernet cable to connect the second Device (Device-2) LAN port to the first Device (Device-1) LAN port. Wait until the POWER and LINK LEDs on Device-2 are steady green.

Step 3: Unplug the Ethernet and power cable from the Device-2.

Step 4: Place the Device-2 where you want to extend your wireless network.

Step 5: Plug in the power adapter. Make sure your LINK LED is steady green. Move the Device-2 closer to the Device-1 if the LINK LED is red.

To add more extenders to your network, repeat from step 2.

Note: In this scenario, do not unplug the Ethernet cable connecting the Device-1 and Non-MPro Mesh Router.

LED Indicator Table (Scenario 2)