NÖDMAST LED Lamp
Assembly and User Guide
Safety Information ⚠️
- For indoor use only.
- The light source of this luminaire is not replaceable; when the light source reaches its end of life, the whole luminaire shall be replaced.
- This product is not intended for children due to electrical components. Adults should handle charging. Regularly examine cord, plug, enclosure, and other parts for damage. Do not use if damaged. Only to be supplied at SELV (Safety Extra Low Voltage).
- Use only batteries intended for the product. Do not mix old and new batteries, or batteries of different brands or types.
Assembly Instructions ?️
Follow these steps to assemble your NÖDMAST lamp:
Step 1: Attach Pole to Base
Insert the pole into the base. Secure it using two screws and nuts. The diagram shows a screw being inserted through the base and pole, secured by a nut.
Step 2: Attach Lampshade
Place the lampshade over the top of the pole. Secure it using two screws and nuts. The diagram shows screws being inserted through the lampshade support and pole, secured by nuts.
Step 3: Insert Batteries
Open the battery compartment cover by unscrewing it. Insert four AA/HR6 batteries, observing the correct polarity (+ and -). Close the battery compartment cover by screwing it back on.
Battery Information ?
- Rechargeable batteries are sold separately.
- IKEA recommends LADDA rechargeable batteries (2450 mAh HR06 AA 1.2V).
- 4 pieces are required.
Charging Information ?
- USB-C cable and USB charger are sold separately.
- Power requirements: 5V DC Min 1A, SELV.
LED Indicator Status ?
- White LED pulsing on: Charging in progress.
- White LED steady on: Charging complete.
- White LED flashing: Error.
- The white LED indicator will flash if batteries are inserted incorrectly, or if non-rechargeable or damaged batteries are inserted by mistake.
